Craftsman 917.27084 manual Acceleration Test, Tractor, Fuel System

Page 29

•While still holding throttle lever against idle speed screw, tum idle mixture screw in(clockwise) until engine begins to die and then turn out (countemlock-

wise) until engine runs rough. Tum screw to a point midway between those two positions.

•Continue to hold throttle lever against idle speed screw and adjust idle speed screw to obtain 900 to 1200 RPM. Re- lease throttle lever.

ACCELERATION TEST

•Move throttle control lever from slow to

fast position. If engine hesitates or dies, turn idle mixture screw out (counter- clockwise) 118 turn. Repeat test and continue to adjust, if necessary, until engine accelerates smoothly.

High speed stop is factory adjusted. Do not adjust - damage may result. IMPORTANT: Never tamper with the engine govemor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed set- ting can be dangerous. If you think the

Immediately prepare your tractor for stor- age at the end of the season or if the trac- tor will not be used for 30 days or more.

,ACAUTION: Never store the tractor with

gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before stor- ing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. This will allow you to clean it thor- oughly. Remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See "CLEANING" in the Maintenance section of this manual).

•Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear.

Replace if necessary.

•Touch up all rusted or chipped paint sur- faces; sand lightly before painting.

engine-governed high speed needs adjusting, contact your nearest authorized service center/department, which has proper equipment and experience to make any necessary adjustments.

Idle Speed

Idle Mixture Scre_

Throttle Lever

Idle Speed

Screw

_Idle Mixture

Screw

Throttle Lever

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected

and battery cleaned thoroughly (see =TO

CLEAN BATTERY AND TERMINALS" in the Maintenance section of this manual).

•After cleaning, leave cables disconnect- ed and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent

gum deposits from forming in essential fuel system parts such as carburetor, fuel filter, fuel hose, or tank during storage. Also, experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Sears Craftsman Help Line 5 am 5 pm, Mon- Sat CRAFTSMAN+Safety Repair Parts Parts Ordering Back CoverProduct Specifications Limited 90 DAY Warranty on BatteryChildren ServiceSlope Operation Do notTY is Involved Maintenance Agreement Product SpecificationsHex Bolt 5116-18 x 1-1/4 Parts Bag contents shown full size16 x Hex BoAtParts packed separately in carton Parts Bag contents not shown full sizeBefore Rolling Tractor OFF Skid Tools Required for AssemblyCheck Battery HOW to SET UP Your TractorInstall Seat Adjustment KnobHooks To Convert to Bagging or DischargingCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemH L Page Mower Blades HOW to USE Your TractorGround Drive EngineTo Transport Towing Carts and Other AttachmentsTo Operate Mower To Operate on HillsBefore Starting the Engine RGE Transmission Mowing TipsBe sure the tractor is on level ground Avoid cutting your lawn when it is wet Maintenance Schedule Lubrication ChartCustomer Responsibilities Before Each USETo Sharpen Blade BrakeoperationEngine To Service Cartridge To Service PRE-CLEANERAIR Filter Engine Cooling RNSTo Install Mower CleaningFuel Filter To Remove MowerSIDE-TO-SIDE Adjustment To LevelmowerhousingFRONT-TO-BACK Adjustment To Replace Mower Blade DriveTo Adjust Brake To Replace Motion Drive Belt BeltinstallationStationaryIdler Transmission Engine Pulley Clutching IdlerRRANSMISSION REMOVAL/REPLACE- Ient To Start Engine with a Weak BatteryFront Wheel TOE-IN/CAMBER To Remove Wheel for RepairsTo Remove CABLES, Reverse Order Replacing BatteryTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor Final SettingFuel System Acceleration TestTractor Other CylindersCorrection Roubleshooting ChartProblem Cause Problem Troubleshooting ChartBattery will not charge Loss of ddve Reinstall blades sharp edgeCheck tires for proper air pres SureTractor --MODEL Number Electrical KEY Part Description Tractor - Model NumberTractor - Model Number Chassis and Enclosures KEY Part NO. NO.DESCRIPTION Tractor - Model Number Chassis and EnclosuresTractor - Model Number Rounddrive GaLe TRACTOR- Model NumberBo,ng Ground Drive KEY Part DescriptionTractor - Model Number Steeringassembly KEY Part Description Tractor - Model Number Steering AssemblySpark Arrester NgineOptional Equipment Inch 25A mm Engine KEY Part DescriptionOarm Hose B Spacers128 x 9snc Tractor - Model Number 917.270840 SeatassemblyKEY Part NO. no KEY PartTractor -- Model Number DecalsWheels & Tires One1718 15 ,.\ 16\\ Tractor - Model Number IFT AssemblyTractor - Model Number Lift Assembly Tractor - Model Number Mower Deck Ang, Ball Ng. pTractor - Model Number Iydro Gear Transaxle - Model Number Tractor - Model Number Hydro Gear Transaxle - Model Number 2set 11010LABELKrr J 5i7,2,2 o3 797 544801 513 803797AGasket SET 634Seal-Oil Spring-ValveExhaustKEY Part NO. NO. Description BodyTW,N CYL Bigines SchematicPage Only Ride UP and Down Hill Not Across Hill Suggested Guide for Sighting Slopes for Safe OperationSears

917.27084 specifications

The Craftsman 917.27084 is a versatile lawn tractor that represents the brand's commitment to quality, performance, and ease of use. Known for its powerful engine and user-friendly design, the Craftsman 917.27084 is an ideal choice for homeowners looking to maintain their lawns with efficiency and precision.

At the heart of the 917.27084 is a robust 24 horsepower Briggs & Stratton engine. This engine provides ample power for various mowing tasks while ensuring durability and reliability. The engine is equipped with a hydrostatic transmission system, allowing for smooth acceleration and effortless control, making it easier to navigate around obstacles and tight spaces in your yard.

One of the standout features of the Craftsman 917.27084 is its cutting deck. It boasts a 42-inch cutting width, allowing for efficient mowing of medium to large-sized lawns. The deck is adjustable to multiple cutting heights, giving users the flexibility to achieve their desired lawn appearance. This adaptability is particularly beneficial for those who prefer a well-manicured lawn or want to tailor the cut for different grass types or seasonal needs.

The tractor also includes a comfortable and spacious operator's seat, which is designed for extended use without causing fatigue. The ergonomic steering wheel and control layout further enhance the user experience by making it easy to maneuver the tractor.

Safety is a critical concern with any lawn equipment, and the Craftsman 917.27084 does not disappoint. It includes features such as an automatic safety shut-off system that activates the engine when the operator leaves the seat, minimizing the risk of accidents. Additionally, the front and rear wheels are designed with enhanced traction, ensuring stability on various terrains.

Furthermore, the Craftsman 917.27084 incorporates advanced technology for improved performance. The Easy Start system means that users can quickly get the engine running without hassle. The maintenance-free battery and integrated LED headlights add convenience and increase usability, making it easier to mow at any time of day or in low-light conditions.

Overall, the Craftsman 917.27084 combines power, comfort, and advanced features, making it a reliable choice for lawn care enthusiasts. Whether you have a small yard or a larger property, this lawn tractor provides the right balance of performance and user-friendly design. It’s an investment that simplifies lawn maintenance, allowing you to spend less time mowing and more time enjoying your outdoor space.
Top Page Image Contents