INSTALLINGOPTIONAL ATTACH*
MENT
1.Remove the tube cap from the at- tachment (if present)and discard.
2.Position locking/release button of attachment into guide recess of upper tube coupler.
Coupler Primary Hole
Upper Locking/ Attachment
Tube Release
Button
3.Push the attachment into the cou- pler until the locking/release button snaps into the primary hole.
4.Before using the unit, tighten the knob securely by turning clock- wise.
INSTALLING ATTACHMENT HANGER
An attachment hanger is provided for storage when attachment is not in use. To install hanger on attachment:
1.Remove the tube cap from the at- tachment (if present) and discard.
2.Press and hold the locking/release button.
3.Push hanger onto the attachment until the locking/release button snaps into the hole.
OPERATING POSITION
ALWAYS WEAR:
Heavy, _Protection
Long Pants
Boots _,.
NOTE: This brushcutter attachment is
not designed for use with electric pow- erheads.
When operating unit with brushcutter attachment, clip shoulder strap onto upper shoulder strap clamp, stand as shown and check for the following:
•Wear eye protection and heavy clothing.
•Keep arms extended with right hand
holding the trigger handle of power- head.
•Keep left arm extended with left hand holding the handlebar.
•Keep unit below waist level.
•Shoulder strap pad should be cen- tered on your left shoulder and dan- ger sign centered on your back.
•Maintain full weight of tool on left shoulder.
•Without bending over, keep the blade near and parallel to the ground and not crowded into material being cut.
OPERATING INSTRUCTIONS FOR
USE OF BRUSHCUTTER ATTACH* MENT WITH TRIMMER HEAD
_l_ WARNING: Always wear eye
protection. Never lean over the trim- mer head. Rocks or debris can rico-
chet or be thrown into eyes and face and cause blindness or other serious
injury.
Before trimming, bring engine to a speed sufficient to cut material to be trimmed.
De net run the engine at a higher speed
than necessary. The cutting line will cut efficiently when the engine _srun at less
than full throttle. At lower speeds, there is less engine noise and vibration. Al- ways release the throttle trigger and allow the engine to return to idle speed when not cutting.
CUTTING METHODS
_I_WARNING: Use minimum speed and do not crowd the line when cutting around hard objects (rock, gravel, fence posts, etc.), which can damage the trimmer head, become entangled in the line, or be thrown causing a seri- ous hazard.
•The tip of the line does the cutting. You will achieve the best perform- ance and minimum line wear by not crowding the line into the cutting area. The right and wrong ways are shown below.
Tip of line does the Line crowded into
Right | i Wrong |
11