SPECIALNOTICE:Exposuretovibra- tionsthroughprolongeduseofgasoline poweredhandtoolscouldcauseblood vesselornervedamageinthefingers, hands,andointsofpeoplepronetocir- cuatondsordersabnormaswerigs. Prolongeduseincoldweatherhasbeen linkedtobloodvesseldamageinother- wisehealthypeopleIfsymptomsoccur.
suchas numbness, pain, loss of strength, change in skin color or texture,
CARTON CONTENTS
Check carton contents against the fol- lowing list.
Model 358.792440
•Brushcutter Attachment
•Handlebar (with Clamp and Knob)
•Handlebar Clamp Base (with Spacer Tabs)
or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An anti-
vibration system does not guarantee the avoidance of these problems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condition of this tool.
SAVE THESE INSTRUCTIONS
Coupler
LOOSEN
•Shoulder Strap
•Upper Shoulder Strap Clamp
•Lower Shoulder Strap Clamp (with Spacer Tabs)
Handlebar Clamp Screws (4) Shoulder Strap Clamp Screws (2) Large nut for installing blade
Cupped washer Trimmer head
•Wing nut (screwed onto shield)
•Metal shield (assembled on brush- cutter attachment)
•Plastic shield
•Attachment Hanger
•Hex Wrench
•Container of line
Examine parts for damage. Do not use damaged parts.
NOTE: If you need assistance or find that parts are missing or damaged, call
ASSEMBLY
all, WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.
•A hex wrench (provided) is required for assembly.
INSTALLING BRUSHCUTTER AT- TACHMENT
CAUTION: When removing or instal- ling attachments, place the unit on a flat surface for stability.
1.Loosen the coupler by turning the knob counterclockwise.
TIGHTEN Knob
2, Remove the tube cap from the brushcutter attachment (if present).
3.Position locking/release button of attachment into guide recess of coupler.
4.Push the attachment into the cou- pler until the locking/release button snaps into the primary hole.
5.Before using the unit, tighten the knob securely by turning clock- wise.
Coupler Primary Hole
\/Guide Recess
Up!er L°ckin_g/[_
Tube Release Attachment
Button
all}WARNING: Make sure the lock-
ing/release button is locked in the pri- mary hole and the knob is securely tightened before operating the unit.
HANDLEBAR ASSEMBLY
DANGER: RISK OF CUT To
avoid serious injury, the barrier portion of the handlebar must be installed as
shown on the upper tube of the power- head to provide a barrier between op- erator and the spinning blade. Attach tube clamp above arrow on safety warn- ing decal on the upper tube (powerhead end of unit). Ensure handlebar is posi- tioned on handlebar clamp between the arrows on the handlebar decal.
5