Howto SET-UPYOUR CHIPPER-SHREDDER

Spacers_Housing

Hex Bolt

Chute

Deflector

Hex

Nut

Hand

Knob

\\\

FIGURE2.

Stop

HopperWasher

Door

					\
					Upper
					Guide
			Release		Assembly
			Bar
				Bolt
			8-3/8"	Long
//	Inlet		Flat Washer
/	Guide		Hex Lock		Nut
FIGURE	3.
	Hopper	Pivot	Hopper Assembly
	Door
					Upper
					Leaf Ramp
Bar					Section
				Remove Truss
				Screw and Nut
		Guide		(Assemble
		Assembly			First)
FIGURE	4.

.Plunger

FIGURE 5.

MAKE CERTAIN THE SPARK PLUG

AWAY FROM THE SPARK PLUG

_hb WIRE IS DISCONNECTED AND MOVED

BEFORE ASSEMBLING THE CHIPPER-

SHREDDER. REFER TO FIGURE 13, PAGE 11.

"<-ATTACHINGTHE CHUTE DEFLECTOR

•Remove the hand knobs and cupped washers from each side of the discharge opening on the left side of the chipper-shredder.

•Remove hex lock nut, two spacers and hex bolt using two 7/16" wrenches from inside the hinge on top of the housing assembly. Do not remove one spacer from the hex bolt.

•Place the chute deflector in position on the dis- charge opening. Insert hex bolt and spacer through hinge on chute deflector and housing (spacer fits inside of hinge). See figure 2.

•Place second spacer over hex bolt, inside other part of hinge. Secure with hex lock nut. Tighten securely.

•Secure both sides of chute deflector to housing using hand knobs and cupped washers (cupped side

of washers go against chute deflector).

"<-ATTACHINGTHE UPPER GUIDE ASSEMBLY

Grasp the upper guide assembly from the sides and squeeze in and slide it over the inlet guide so the

edges are under the stop washers. Adjust so the holes in the upper guide assembly are aligned with the holes in the inlet guide. Insert the hex bolt 8-3/8" long through the upper guide assembly and the inlet guide. Secure with flat washer and lock nut.

NOTE: Make certain the upper guide assembly can pivot by lifting it up until it locks in the raised position. If it does not pivot freely, loosen the hex lock nut a turn or two and test.

THE HOPPER ASSEMBLY

Your chipper-shredder has been shipped with the upper leaf ramp section attached to the hopper assembly. See figure 4. Attach the hopper assembly to the upper guide assembly as follows. Be certain to place heads of all truss machine screws inside of hopper assembly.

•Remove one truss machine screw and nut from each side of hopper assembly as shown in figure 4.

Push hopper pivot door down inside lower part of hopper as you place hopper assembly (both pieces) inside upper guide assembly. Replace truss screws and nuts just removed, using the hole shown in figure 4, one on each side. Tighten finger tight only.

NOTE: You may have to squeeze in the sides of the hopper to start the screws. If you have difficulty align- ing the holes, loosen the two screws on the upper end of the hopper assembly.

•Place the six truss machine screws and nuts found in hardware pack in the remaining holes of hopper assembly, alternating sides of the unit and tighten- ing finger tight only.

•After assembling all eight screws, tighten them

securely.

_'-ATTACHINGTHE CATCHER BAG

Your chipper-shredder is equipped with a catcher bag to catch the shredded material.