Craftsman 917.377592 To Adjust Cutting Height, To REMOVE/REPLACE Drive Belt, To Adjust Handle

Page 14

CAUTION: Beforeperformingany serviceoradjustments.

oReleasecontrolbarandstopengine o Makesurethebladeandallmoving

partshavecompletelystopped.

o Disconnectsparkplugwirefromspark

plug and place where it cannot come in contact with plug

LAWN MOWER

TO ADJUST CUTTING HEIGHT

See "TO ADJUST CUTTING HEIGHT" in the

Operation section of this manual

REAR DEFLECTOR

The rear deflector, attached between the rear wheels of your lawn mower, is provided to minimize the possibility that objects will be thrown out the rear of the lawn mower into the operator'smowing position. If the rear deflector becomes damaged, it should be replaced.

TO REMOVE/REPLACE DRIVE BELT

°Remove drive cover_ Remove belt by

pushing down on gear case pulley and roll belt off.

- Turn lawn mower on itsside with carburetor

and fuel cap up.

• Remove blade,

- Remove debris shield.

,,Remove belt from engine pulley on crankshaft,

= Install new belt by reversing above steps.

. Always use factory approved belt to assure fit and long life.

Drive

cover

Belt

Push down

TO ADJUST HANDLE

°Remove the starter rope guide from the upper handle

°Remove hairpin cotters.

°Disconnect the lower handle from the handle brackets.

°Turn the handle over and reassemble the

hairpin cotters that have been removed.

. Reassemble the starter rope guide

. Reassemble the controls and the operator presence control bar to the upper handle CAUTION: The operator presence control bar must pivot freely to permit blade brake engagement when control bar is released.

Do not over tighten the fasteners holding the controls to the upper handle.

•To change from medium low to high

position only the upper'handle section will have to be turned over,.

°To change from medium low to low position, only the lower handle section will have to be turned over,.

Shipping position

Medium low

high

Low

High

Your'lawn mower handle can be raised or lowered for your mewing comfort, Four (4) positions are available: high, medium high, medium low and tow, Handles are shipped mounted in the medium low position_

o To change from medium low to medium

high position, the upper and lower handle sections will have to be turned over.

• Remove cable clips.

\

Squeeze to remove

Lower handle

o Remove the controls and operator presence centre{ bar from the upper handle,

Hairpin clil	Har_dle
	bracket

14

Image 14

Contents Cautron Training Limited TWO Year Warranty on Craftsman Power MowerSEARS, Roebuck and CO., D/817 WA, Hoffman ESTATES, Illinois PreparationOperation To Remove Lawn Mower from Carton Lawn Mower PerformanceWERMAINTE To Unfold HandleMowing position Engine zone control cable Housing Drive cover Gasoline cat Wheel adjuster PrimeMeets Cpsc Safety Requirements Engine Zone Control Howto USE Your Lawn MowerEngine Speed To Aitachgrass CatcherBefore Starting Engine Drive ControlGAS OILMowingtips Mulching Mowing TipsManual Lubrication ChartGeneral Recommendations Before Each USEErial Number MowerGear Case LubricationTo Sharpen Blade Grass CatcherAIR Filter To REMOVE/REPLACE Drive Belt To Adjust Cutting HeightTo Adjust Handle Remove drive cover Remove belt byLower frame CarburetorTo Assemble Grass Catcher FullyHandle Engine Fuel SystemCause ProblemDoes not start CorrectionExcessive vibration Starter rope hard To pull ProblemLoss of power Grass catcher Not filling if so equipped Hard to pushEntrenamiento Momento Mantenimiento Y ALMACENAMIEN- toMantenimiento DE LA Segadora LA Caja DE CartonRendimiento DE LA Segadora Papa Remover LA Segadora DEPapa Instalar LOS Accesorios Bata de control que exige la presencia del operadoPosici6n Para segar Mango inferior Faiviiliaricese CON SU Segadora Cumple CON LOS Requisitos DE Seguridad DE LA CpscPara Montar Y Adjuntar EL Control DE Zona DEL MotorPara Ajustar LA Altura DE Corte Papa Vaciar EL Recogedor DE CspedAntes DE Hacer Arrancar EL Motor Aceite GasolinaConsejosparasegaryacolchar ConsejosparasegarPara Hacer Arrancar EL Motor Tabla DE Lubricacion Tabla DE LubricaconLubricacion Llantas SegadoraRegular Del relojNtmerodel modeode lasegadora cuando Io ordene Para Afilar LA CuchillaRecogedor DE Cesped Caja DE EngranajesPara Cambiar EL Filtro DE Aire LimpiezaFilifiode Aire BujiaDesviador Trasero Segadora Para Ajustar LA Altura DE CartePara Ajustar EL Mango Para Removepjcambiar LA Correa DE ImpulsionMarco del bastidor CarburadorBarra de control que exige la presencia dalo F MotorSegadora CombustibleAceitedel Motor ProblemaDE Problemas Causa OtrosCord6n arncador dificildetimr Problema CausacorreccionMal corte -disparejo Dificil de empujarPage Description NOoKEY Rotary Lawn Mower Model Number Rotary Lawn Mower Model Number KEY Part Description NO. noRotary Lawn Mower Model Number KEY Part Description Rotary Lawn Mower Model NumberKEY Part Craftsman 4-CYCLE Engine KEY Part Craftsman 4-CYCLE Engine KEY Part DescriptionModel Number KEY Part NOo DESCRIPflONCraftsman 4-CYCLE Engine Part DescriptionPage Page Para ordenar piezas con entrega a domicilio REV.1Call 7 arn 7 pro, 7 days a week 1-800-366-PART 800-4737274 Para pedJr servicio de reparaci6n a domicilio