REPLACE SPARK PLUG
Replace spark plug each year to ensure the engine starts easier and runs better. Set spark plug gap at 0.025 inch. Igni- tion timing is fixed, nonadjustable.
1.Twist, then pull off spark plug boot.
2.Remove spark plug from cylinder and discard.
3.Replace with Champion
4.Reinstall the spark plug boot.
REPLACE FUEL FILTER
To replace fuel filter, drain unit by run- ning it dry of fuel, then remove fuel cap/retainer assembly from tank. Pull filter from tank and remove it from the fuel line. Install new fuel filter on fuel
line; reinstall parts.
Fuel Filter
A
il_ WARNING: Perform the following steps after each use:
•Allow engine to cool, and secure the unit before storing or transporting.
•Store unit and fuel in a well venti-
lated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.
•Store unit with all guards in place. Position unit so that any sharp object cannot accidentally cause injury.
•Store unit and fuel well out of the reach of children.
SEASONAL STORAGE
Prepare unit for storage at end of sea- son or if it will not be used for 30 days or more.
If your unit is to be stored for a period of time:
CHECK MUFFLER MOUNTING SCREWS
Once each year, ensure muffler mounting screws are secure and tight- ened properly to prevent damage.
Mounting
1.Loosen and remove the 2 screws from the muffler cover.
2.Remove the muffler cover.
3.Tighten the 2 muffler mounting screws securely.
4.Reinstall muffler cover and 2
screws. Tighten securely.
CARBURETOR ADJUSTMENT
There is no screw for idle adjustment on your blower. The throttle lever is used to control engine speed. The throttle lever can be placed in one of four positions: STOP, IDLE or _, FULLTHROTTLE or '(_, and one inter-
mittent position. | If your engine will |
not run properly or you require further
assistance, contact your Sears Service Center or call our customer assistance
help line at
•Clean the entire unit before lengthy storage.
•Store in a clean dry area.
•Lightly oil external metal surfaces.
FUEL SYSTEM
Empty tile fuel system before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until
the fuel lines and carburetor are empty. Use fresh fuel next season.
Under FUELING ENGINE in the OPERA- TION section of this manual, see mes- sage labeled IMPORTANT regarding the use of gasohol in your engine.
Fuel stabilizer is an acceptable alterna- tive in minimizing the formation of fuel gum deposits during storage. Add stabi- lizer to gasoline in fuel tank or fuel stor-
age container. Follow the mix instruc- tions found on stabilizer container. Run
engine at least 3 minutes after adding stabilizer.