Operating Position, Before Starting Engine

•Use rakes and brooms to loosen debris before blowing.

•In dusty conditions, slightly dampen surfaces or use a mister attachment

when water is available.

•Conserve water by using power blow- ers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches, and gardens.

•Watch out for children, pets, open windows, or freshly washed cars. Blow debris away safely.

•Use the full blower nozzle extension so the air stream can work close to

the ground.

•After using blowers and other equip- ment, CLEAN UP! Dispose of debris in trash receptacles.

OPERATING POSITION

Protection

BJowerVacuum

fuel, follow instructions printed on con- tainer. Once oil is added to gasoline, shake container momentarily to assure that the fuel is thoroughly mixed. Always read and follow the safety rules relating to fuel before fueling your unit.

IMPORTANT

Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract mois- ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel sys- tem of an engine while in storage.

To avoid engine problems, empty the fuel system before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season.

Never use engine or carburetor clean- er products in the fuel tank or perma- nent damage may occur.

Fuel stabilizer is an acceptable alter- native in minimizing the formation of fuel gum deposits during storage.

Craftsman brand oil is already blended with fuel stabilizer. See the STORAGE

section for additional information.

NOTE: Unit must be placed on its side when adding fuel (see illustration below).

BEFORE STARTING ENGINE

_,WARNING:

Be sure to read the

fuel information in the safety rules before you begin. If you do not understand the safety rules, do not

attempt to fuel your unit. Call 1-800-235-5878.

FUELING ENGINE

_f_,WARNING: Remove fuel cap

slowly when refueling.

This engine is certified to operate on un- leaded gasoline. Before operation, gaso- line must be mixed with a good quality synthetic 2-cycle air-cooled engine oil. We recommend Craftsman brand syn- thetic oil. Mix gasoline and oil at a ratio of 40:1. A 40:1 ratio is obtained by mix- ing 3.2 ounces of oil with 1 gallon of un-

leaded gasoline. Included with this blower is a 3.2 ounce container of oil.

Pour the entire contents of this container

into 1 gallon of gasoline to achieve the

proper fuel mixture. DO NOT USE auto- motive oil or boat oil. These oils will

cause engine damage. When mixing

-9-

HOW TO STOP YOUR ENGINE

•To stop the engine, move the throttle lever to the STOP position.

HOW TO START THE ENGINE

,_ WARNING: You MUST make sure

the tubes are secure before using the unit.

•Fuel engine. Move at least 10 feet (3 meters) away from the fueling site.