CARTON CONTENTS
Check carton contents against the fol-
lowing list.
Model 358.794964
•Blower
•Blower tube
•Elbow tube
•Vacuum bag
•Upper vacuum tube
•Lower vacuum tube
•
NOTE: It is normal for the fuel filter to rattle in the empty fuel tank.
ASSEMBLY
_WARNING: | Stop engine and be |
sure the impeller blades have stopped turning before opening the vacuum in- let door or attempting to insert or re- move the vacuum tubes. The rotating blades can cause serious injury.
,_ WARNING: | If you receive your |
unit assembled, repeat all steps to en- sure your unit is properly assembled and all fasteners are secure.
•A standard screwdriver is required for assembly.
BLOWER ASSEMBLY BLOWER TUBE ASSEMBLY
If you have already assembled your unit for use as a vacuum, remove the vacuum tubes and collection bag.
1. Align the rib on the blower tube with the groove in the blower outlet; slide the tube into place.
NOTE: Knob must be loose enough to allow blower tube to be inserted in blow-
er outlet. Loosen knob by turning coun- terclockwise.
jox _ Blower
_\Outlet Blower
VACUUM ASSEMBLY
VACUUM BAG ASSEMBLY
1.Open the zipper on the vacuum bag and insert the elbow tube.
2.Push the small end of the elbow tube through the small opening in
the bag. Elbow
Tube
Small Opening
OpeningRib
NOTE: Make sure edge of the small opening is flush against the flared area
of the elbow tube, and the rib on the elbow tube is on the bottom.
3.Close the zipper on the bag. Make sure the zipper is closed completely.
4.Remove blower tube from engine.
e
5.Insert the elbow tube into the blower outlet. Make sure elbow tube is
aligned with the blower outlet groove.
6.Turn knob clockwise to secure elbow tube.
VACUUM TUBE ASSEMBLY
1.Align the lower vacuum tube as shown. Push lower vacuum tube
into upper vacuum tube. Upper
Groove _ _ Rib
2.Secure the tube by turning the knob clockwise.
3.To remove the tube, turn the knob counterclockwise to loosen the tube; remove the tube.
Lower
Vacuum Tube
2.Insert the tip of a screwdriver into the latch area of the vacuum inlet.