Craftsman 358.351080 File Holder, Inside, Side Plate, Remove Sawdustlf, Sprect Hole, File Edges

CUSTOMER RESPONSIBILITIES

1 FULL VtEW ]

I SIDE VIEW I	1FRONT VIEW 1
File Holder

"-Guide Bar

& Chain

Figure 23

Outside

/

Inside_

Figure 24

File

Holder

Figure 25

Cutters Same

2e°o ,t Remove Damage

n

Side Plate Top Plate

Figure 26

I

I

30o

Figure 27

GUIDE BAR MAINTENANCE (Fig. 28 & 29) Conditionswhich requireguide bar maintenance:

•saw cuts to one side orat an angle.

•saw has to be forced through the cut.

•inadequate supply of oilto the bar and chain.

Check the conditionof the guide bar each time the chain is sharpened, A worn guide bar will damage the chain and make cuttingdifficult.

•Move on/stop switch to the "Stop _position.

•Remove bar and chain from saw.

•Clean all saw dust and any other debris from the guide bar groove and guide bar lubrication hole. Figure 28.

•Lubricate guide bar hole sprocket after each use. Figure

28.

•Burring of bar rails is a normal process of guide bar rail wear. Remove these burrs by filing guide bar rail side edges square with a flat file. Figure 29.

•Restore square edges to an uneven rail top by filing with a flat file. Figure 29.

Remove Sawdustl_f'

From Guide Bar Groove _ j_7_

- Sprec_t Hole

CRRFTSMRN"•

Figure 28

Replace the guide bar when:

•the inside grooveof the guide bar rails is worn.

•the guide bar is bent or cracked.

•excess heating or burring of the rails 'is noted.

If replacement is necessary, use only the repiacernent reduced kickback guide bar specified for your saw in the

repair parts list or as specified on the replacement bar and chain decal locat_ Onthe chain saw.

Correct	Worn Grooves	File Edges
Groove		Square
	Figure 29

-19-