ASSEMBLY
ASSEMBLY
1. From Shipping Position (FLX15/10)
The Flex arms will be shipped almost completely as- sembled. Remove the flex arm from the trailer using an overhead boom. Attach chains to the flex arm using the three lifing hooks in the locations shown. The lengths of the chains may need to be adjusted to provide a level lift of the flex arm.
Use the following procedure to get your implement field ready.
Block the flex arm under the frame at point "A".
Remove the four shipping brackets, "B"and discard.
Break the bands securing the arm strut "C" and the castor link * "D".
Swing the hitch forward and connect the arm strut to hitch at point "E". Use the 1/2" bolt, lock washer, and flat washer to tighten the pin.
Connect the castor link to the castor arm at point "F" using the provided pin and hardware. * Face the pinhead upwards.
Connect to the tractor drawbar and remove the blocking.
Drive the flex arm ahead to straighten the left wheel standard. *
Connect the other end of the castor link to the arm frame "G" using the provided pin and hardware. *
*Does not apply to the FLX10.
FLX15/10 04/06 | Assembly Section |
© 2006 Alamo Group Inc.