OPERATION
4. STARTING THE TRACTOR
The operator must have a complete understanding of the placement, function, and operational use of all tractor controls before starting the tractor. Review the tractor operator’s manual and consult an authorized dealer for tractor operation instructions if needed.
Essential Tractor Controls:
Locate the light control lever
Locate the engine shut off control
Locate the brake pedals and the clutch
Locate the PTO control
Locate the 3 point hitch control lever
Locate the hydraulic remote control levers
Before starting the tractor ensure the following:
Conduct all
Make sure all guards, shields, and other safety devices are securely in place.
The parking brake is on.
The PTO control lever is disengaged.
The
The hydraulic remote control levers are in the neutral position.
The tractor transmission levers are in park or neutral.
Refer to the tractor owner’s manual for tractor starting procedures. Only start the tractor while seated and belted in the tractor operator’s seat. Never bypass the ignition switch by short circuiting the starter solenoid.
After the tractor engine is running, avoid accidental contact with the tractor transmission to prevent sudden and unexpected tractor movement.
OPERATION
DANGER!
DANGER!
Never run the Tractor engine in a closed building or without adequate ventilation. The exhaust fumes can be hazardous to your health.
Start the Tractor only when properly seated in the Tractor seat. Starting a Tractor in gear can result in injury or death. Read the Tractor operator’s manual for proper starting instructions.
5. CONNECTING THE FLEX-ARM TO THE TRACTOR
Use extreme caution when connecting the
DANGER!
Always shut the Tractor completely down, place the transmission in park, and set the parking brake before you or anyone else attempts to connect or disconnect the Implement and Tractor hitches.
FLX15/10 04/06 | Operation Section |
© 2006 Alamo Group Inc.