Walker S14 manual Safety Instructions Before Operating

Page 15

Safety Instructions - Before Operating

6.Do not wear loose fitting clothing that could get caught in moving parts. Do not operate this ma- chine while wearing shorts; always wear ade- quate protective clothing, including long pants. Wearing safety glasses, safety shoes, and a helmet is advisable and required by some local ordinances and insurance regulations.

7.Prolonged exposure to loud noise can cause impairment or loss of hearing. Operator hear- ing protection is recommended; particularly for continuous operation of the GHS Model due to blower noise level. Wear a suitable hearing protective device, such as earmuffs or earplugs.

8.Keep all protective shields and safety de- vices in place. If a protective shield, safety device, or decal is damaged, unusable, or miss- ing, repair or replace it before operating the machine.

9.Be sure interlock switches are functioning correctly, so the engine cannot be started un- less the Forward Speed Control lever is in the NEUTRAL-PARK position, and the PTO clutch is in the DISENGAGED position. Also, the en- gine should stop if the operator lifts off the seat with either the Forward Speed Control (FSC) out of the NEUTRAL-PARK position or the PTO clutch in the ENGAGED position.

10.Handle gasoline with care. Gasoline is highly flammable and its vapors are explosive:

a.Use an approved fuel container.

b.Never add fuel to a running engine or hot engine (allow hot engine to cool several min- utes).

c.Keep matches, cigarettes, cigars, pipes, open flames, or sparks away from the fuel tank and fuel container.

d.Always fill the fuel tank outdoors using care.

Fill to about one inch from the top of the tank. Use a funnel or spout to prevent spilling.

e.Replace the machine fuel cap and container cap securely and clean up any spilled fuel before starting the engine.

11.Never attempt to make any adjustments while the engine is running, except where specifically instructed to do so.

12.The electrical system battery contains sulfuric acid. Avoid any contact with skin, eyes, and clothing. Keep the battery and acid out of reach of children.

WARNING

The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.

11

Image 15
Contents Operator’s Manual Foreword Table of Contents Maintenance Schedule Chart Important Tips for Care Fill In By Purchaser General InformationGlossary Identifying Number LocationsServicing of Engine and Drivetrain Components Transmission SpecificationsEngine Electrical SystemBlade Drive Tire SizeTire Pressure PSI KPA Height in. cm Dimensions Tractor and Mower Length in. cmWeight lb kg Width in. cmMower Deck Drive BeltsSeat Front View and Right Side View Component IdentificationRear View and Left Side View Top View Body Raised Safety Instructions Before Operating Before OperatingDo not mow with bystanders in the area Safety Instructions Before Operating Safety Instructions Operating Safety Instructions Operating Safety Instructions Maintenance Location Chassis Member Behind Transaxles Part Number Safety InstructionsLocation Top of Fuel Tank Part Number Location Gearbox Cover Gear Drive Decks Only Part NumberLocation Each End of Mower Deck Part Number Location Deck Discharge Shield SD Decks Only Part NumberLocation Deck Gearbox Cover Part Number Location RH Fender Part Number Location LH Fender Part NumberAssembly Instructions Setup InstructionsBattery Service Batteries Produce Explosive Gases Battery InstallationBattery Installation Mower Deck Assembly Deck Caster Wheels InstallationDeck Caster Wheel Installation Discharge Shield Installation On Side Discharge DeckPTO Shaft Guard Installation PTO Shaft Connection Deck InstallationMower Deck Installation Deck Counterweight Spring InstallationMachine must be shut off during this procedure Deck LevelingDeck Leveling Refer to Lubrication for Transaxle Lubrication Fill Fuel TankBlades in Maintenance Instructions Engine Choke Ignition Switch Key PositionsOperating Instructions Control IDENTIFICATION, LOCATION, and FunctionBlade Clutch PTO Engine ThrottleChoke and Throttle Location Forward Speed Control FSC Steering LeversHydro Lockout Arm Location Parking BrakeHourmeter Operating Controls Top View from Drivers Point of View Left Wheel Steering Leverright WheelAdjusting Ground Speed and Steering Starting the EngineEngaged Beginning Recommendations are Forward Speed Control Friction AdjustmentCorrect Operator Hand Position On the Controls Stopping the Machine Blade Clutch EngagedHydro Lockout Arm Normal Operating Position Cutting Height AdjustmentTransaxle Lockouts Hydro Lockout Arm Freewheel PositionRecommendations for Mowing No Driving Zone Side Discharge Deflector Shield Lowest PositionRecommendations for TILT-UP Deck OPERATION/TRANSPORT GHS Flow and Components GHS Model OnlyRotating Blower Blades General InformationForward Clogging ChecklistUsing the Tilt-Up Deck PowerfilFull Signal Horn Tailgate Dumping Using the Dump Bag Positioning Dump Bag on CatcherDumping Catcher into Dump Bag Hours Maintenance InstructionsMaintenance procedures requiring special training or Service Item 100 400 EveryImportant Tips for Care of the Subaru Engine Lubrication Each USENot Screwed Grease Fitting and Oil Point Lubrication Oil Drain Location View from Lower Right Side of TractorDeck and Carrier Frame Illustrated Maintenance Instructions Mower Deck Gearbox Lubrication Transaxle LubricationExpansion Reservoir Location Guard Cleaning Air Cleaner Components Shown with Cover RemovedEngine Air Cleaner System Components Air Filter Element Replacement Proper Orientation of Air Cleaner Cover Fuel FilterFuel Filter and Fuel Shut-off Valve Location Keep Rotating Engine Cooling Air Intake Screen Clean Cooling Air Intake ScreenCooling System Airflow GHS Exhaust Screen Transaxle Cooling Fans Transaxle HousingTransaxle Housing and Cooling Fins BatterySharpen Mower Blades Charging the BatteryTire Pressure Wheel Nut TorqueBlade Balanced on Magnetic Wall-Mounted Balancer Mower Blade Profile for SharpeningDrive Belts Spark PlugIgnition Forward Speed Control Friction Lock Belt Locations REPLACING/REPAIRINGEngine Belt Engine Belt DisengagedEngine Belt Engaged PTO Drive Belt PTO Drive Belt DisengagedPTO Drive Belt Engaged Ground Drive Belt Assembly Disengaged Ground Drive Belt Assembly EngagedGround Drive Belt Blade Overload Shear Bolts Cutting Blade Shear BoltsPTO Shear Pin Mower Blades Lever Alignment AdjustmentsSteering Lever Position Adjustment Transmission ControlSteering Handles Adjustment FSC Lever Position AdjustmentCorrect FSC Lever NEUTRAL-PARK Position Maintenance Instructions FSC Neutral Switch Location FSC Friction Adjustment Nut FSC Friction Adjustment TestPTO Clutch Engaged PTO Clutch Disengaged Blade Brake Band Adjustment Blade Brake Band Adjustment Clutch Disengaged With a little advance warning before overfilling Adjusting the Grass-PakSwitchPinch Point Spring Loaded Door Side View of Catcher BoxOperator’s Notes Operator’s Notes Limited Warranty For Walker Model S14 Rider Mower Walker MFG. CO E. Harmony ROAD, Fort COLLINS, CO 80528 970

S14 specifications

The Walker S14 is an innovative piece of technology designed to enhance mobility and independence for individuals facing mobility challenges. This advanced mobility device integrates cutting-edge features and technologies to deliver a safe and comfortable user experience.

One of the standout characteristics of the Walker S14 is its lightweight yet robust design. Constructed from high-quality materials, the walker provides durability without sacrificing portability. It can easily be maneuvered both indoors and outdoors, making it suitable for various environments.

A significant technological advancement in the Walker S14 is its adjustable height feature. Users can customize the walker to their preferred height, ensuring optimal support and reducing strain on the body. This feature is particularly beneficial for individuals with varying mobility needs, as it promotes a proper walking posture.

Safety is a top priority in the design of the Walker S14. It is equipped with a reliable braking system that enhances stability when stationary. The walker features ergonomic hand grips that provide comfort and reduce the risk of slipping. Additionally, its non-slip wheels are designed to provide a reliable grip on various surfaces, contributing to a safer walking experience.

In terms of storage and convenience, the Walker S14 includes a built-in storage pouch, allowing users to carry personal items or essential belongings. This feature is particularly useful for users who wish to maintain their independence while being able to access their belongings easily.

The Walker S14 is also praised for its sleek and modern aesthetic. With a variety of color options, users can choose a design that reflects their personality while still benefiting from the practicality of the mobility device.

Moreover, the Walker S14 is designed for easy folding and portability. Whether for storage or transport, users can quickly collapse the walker to fit it in tight spaces or vehicles without any hassle.

Overall, the Walker S14 combines innovative technology, user-centric design, and robust safety features to provide an unparalleled walking experience. It empowers individuals with mobility challenges to navigate their surroundings with confidence, fostering independence and a better quality of life.