Walker S14 manual Cleaning the GHS Exhaust Screen, Tailgate Dumping

Page 46

Operating Instructions

Cleaning the GHS Exhaust Screen

To remove the grass catcher screen for cleaning, open the catcher door, push forward and pull down on the grass catcher screen knobs (on either side of the screen), and slide the screen out. Use a high pressure washer or water spray and brush to clean the screen.

Keeping the catcher exhaust screen clean and open is essential to good performance of the catching system. In some mowing conditions, e.g., wet and dirty, it will be necessary to clean the screen fre­ quently to avoid clogging the mower deck, blower, and chutes due to airflow restriction.

Grass Catcher

Screen

Removal

Knobs

Grass Catcher Screen Removal for Cleaning

Dumping the Catcher

DANGER

Do not mow or dump grass within 5 feet (1.5 meters) of an embankment or retaining wall with drop off.

For dumping, the catcher either tailgate dumps into a disposal area or dumps into the optional dump bag. The dump bag is a reusable nylon fabric bag designed to conveniently move grass clippings from the catcher to a remote disposal area or container.

CAUTION

Use leg muscles and firm footing when lifting the catcher to dump; avoid bending at the waist and using back muscles in order to prevent back injury.

Tailgate Dumping

1.Open the back door by lifting on the door handle.

2.Tilt the catcher back to dump by lifting on the catcher lift handle on the lower front corner of the catcher.

3.Lower the catcher smoothly down to the normal operating position. DO NOT allow the catcher to drop down - the gas spring, that holds the catcher in the raised position, is not a shock absorber for lowering the catcher.

4.Close the door by pulling down on the door handle. The door should close smoothly with the assistance of the gas springs. If the dampening springs are not functioning proper- ly, they should be replaced to prevent the door from slamming closed and possibly causing a pinch point.

42

Image 46
Contents Operator’s Manual Foreword Table of Contents Maintenance Schedule Chart Important Tips for Care Identifying Number Locations General InformationGlossary Fill In By PurchaserServicing of Engine and Drivetrain Components Electrical System SpecificationsEngine TransmissionTire Size Blade DriveTire Pressure PSI KPA Width in. cm Dimensions Tractor and Mower Length in. cmWeight lb kg Height in. cmDrive Belts Mower DeckSeat Component Identification Front View and Right Side ViewRear View and Left Side View Top View Body Raised Before Operating Safety Instructions Before OperatingDo not mow with bystanders in the area Safety Instructions Before Operating Safety Instructions Operating Safety Instructions Operating Safety Instructions Maintenance Location Gearbox Cover Gear Drive Decks Only Part Number Safety InstructionsLocation Top of Fuel Tank Part Number Location Chassis Member Behind Transaxles Part NumberLocation Deck Discharge Shield SD Decks Only Part Number Location Each End of Mower Deck Part NumberLocation Deck Gearbox Cover Part Number Location LH Fender Part Number Location RH Fender Part NumberSetup Instructions Assembly InstructionsBattery Service Deck Caster Wheels Installation Battery InstallationBattery Installation Mower Deck Assembly Batteries Produce Explosive GasesDischarge Shield Installation On Side Discharge Deck Deck Caster Wheel InstallationPTO Shaft Guard Installation Deck Counterweight Spring Installation Deck InstallationMower Deck Installation PTO Shaft ConnectionDeck Leveling Machine must be shut off during this procedureDeck Leveling Fill Fuel Tank Refer to Lubrication for Transaxle LubricationBlades in Maintenance Instructions Control IDENTIFICATION, LOCATION, and Function Ignition Switch Key PositionsOperating Instructions Engine ChokeSteering Levers Engine ThrottleChoke and Throttle Location Forward Speed Control FSC Blade Clutch PTOParking Brake Hydro Lockout Arm LocationHourmeter Left Wheel Steering Leverright Wheel Operating Controls Top View from Drivers Point of ViewStarting the Engine Adjusting Ground Speed and SteeringEngaged Forward Speed Control Friction Adjustment Beginning Recommendations areCorrect Operator Hand Position On the Controls Blade Clutch Engaged Stopping the MachineHydro Lockout Arm Freewheel Position Cutting Height AdjustmentTransaxle Lockouts Hydro Lockout Arm Normal Operating PositionRecommendations for Mowing Side Discharge Deflector Shield Lowest Position No Driving ZoneRecommendations for TILT-UP Deck OPERATION/TRANSPORT GHS Model Only GHS Flow and ComponentsGeneral Information Rotating Blower BladesClogging Checklist ForwardPowerfil Using the Tilt-Up DeckFull Signal Horn Tailgate Dumping Positioning Dump Bag on Catcher Using the Dump BagDumping Catcher into Dump Bag Service Item 100 400 Every Maintenance InstructionsMaintenance procedures requiring special training or HoursImportant Tips for Care of the Subaru Engine Each USE LubricationNot Screwed Oil Drain Location View from Lower Right Side of Tractor Grease Fitting and Oil Point LubricationDeck and Carrier Frame Illustrated Maintenance Instructions Transaxle Lubrication Mower Deck Gearbox LubricationExpansion Reservoir Location Guard Air Cleaner Components Shown with Cover Removed CleaningEngine Air Cleaner System Components Air Filter Element Replacement Fuel Filter Proper Orientation of Air Cleaner CoverFuel Filter and Fuel Shut-off Valve Location Cooling Air Intake Screen Keep Rotating Engine Cooling Air Intake Screen CleanCooling System Airflow GHS Exhaust Screen Battery Transaxle HousingTransaxle Housing and Cooling Fins Transaxle Cooling FansWheel Nut Torque Charging the BatteryTire Pressure Sharpen Mower BladesMower Blade Profile for Sharpening Blade Balanced on Magnetic Wall-Mounted BalancerSpark Plug Drive BeltsIgnition Forward Speed Control Friction Lock REPLACING/REPAIRING Belt LocationsEngine Belt Disengaged Engine BeltEngine Belt Engaged PTO Drive Belt Disengaged PTO Drive BeltPTO Drive Belt Engaged Ground Drive Belt Assembly Engaged Ground Drive Belt Assembly DisengagedGround Drive Belt Cutting Blade Shear Bolts Blade Overload Shear BoltsPTO Shear Pin Mower Blades Transmission Control AdjustmentsSteering Lever Position Adjustment Lever AlignmentFSC Lever Position Adjustment Steering Handles AdjustmentCorrect FSC Lever NEUTRAL-PARK Position Maintenance Instructions FSC Neutral Switch Location FSC Friction Adjustment Test FSC Friction Adjustment NutPTO Clutch Engaged PTO Clutch Disengaged Blade Brake Band Adjustment Blade Brake Band Adjustment Clutch Disengaged Side View of Catcher Box Adjusting the Grass-PakSwitchPinch Point Spring Loaded Door With a little advance warning before overfillingOperator’s Notes Operator’s Notes Limited Warranty For Walker Model S14 Rider Mower Walker MFG. CO E. Harmony ROAD, Fort COLLINS, CO 80528 970

S14 specifications

The Walker S14 is an innovative piece of technology designed to enhance mobility and independence for individuals facing mobility challenges. This advanced mobility device integrates cutting-edge features and technologies to deliver a safe and comfortable user experience.

One of the standout characteristics of the Walker S14 is its lightweight yet robust design. Constructed from high-quality materials, the walker provides durability without sacrificing portability. It can easily be maneuvered both indoors and outdoors, making it suitable for various environments.

A significant technological advancement in the Walker S14 is its adjustable height feature. Users can customize the walker to their preferred height, ensuring optimal support and reducing strain on the body. This feature is particularly beneficial for individuals with varying mobility needs, as it promotes a proper walking posture.

Safety is a top priority in the design of the Walker S14. It is equipped with a reliable braking system that enhances stability when stationary. The walker features ergonomic hand grips that provide comfort and reduce the risk of slipping. Additionally, its non-slip wheels are designed to provide a reliable grip on various surfaces, contributing to a safer walking experience.

In terms of storage and convenience, the Walker S14 includes a built-in storage pouch, allowing users to carry personal items or essential belongings. This feature is particularly useful for users who wish to maintain their independence while being able to access their belongings easily.

The Walker S14 is also praised for its sleek and modern aesthetic. With a variety of color options, users can choose a design that reflects their personality while still benefiting from the practicality of the mobility device.

Moreover, the Walker S14 is designed for easy folding and portability. Whether for storage or transport, users can quickly collapse the walker to fit it in tight spaces or vehicles without any hassle.

Overall, the Walker S14 combines innovative technology, user-centric design, and robust safety features to provide an unparalleled walking experience. It empowers individuals with mobility challenges to navigate their surroundings with confidence, fostering independence and a better quality of life.