Walker S14 Adjustments, Transmission Control, Steering Lever Position Adjustment, Lever Alignment

Page 72

Maintenance Instructions

ADJUSTMENTS

ADJUSTMENTS

Transmission Control

IMPORTANT: The proper adjustment of the transaxle control stops is essential for efficient operation and life of the transaxle. These stops are properly adjusted at the factory and should only require read­justment if the transaxle or related control linkage is removed or changed.

NOTE: It would not be unusual for a new machine, after the initial 5 or 10 hours of operation, to begin to not travel straight (this is due to the break-in of the transaxles). To fine tune tracking, refer to Step 5 - Straight Tracking Adjustment in this section.

Step 1 - Steering Lever Position Adjustment

NOTE: For proper operation, the steering levers should be adjusted to sit evenly using the following procedure.

1.Examine the steering levers to make sure they are parallel front to back in relation to one an­ other. If they are not equal, adjust accordingly. (The handles may or may not be even at this point.)

NOTE: The LH steering lever is non-adjust­ able. This procedure will require adjustment of the RH lever to make it even with the LH lever.

Levers should sit

parallel to each other

Lever Alignment

2.Adjust the position of the RH lever by turning the stop bolt in the Speed Control Actuator in or out. Turning the stop bolt in will make the RH lever move back, and turning it out will make it move forward. Tighten the locknut.

Stop

Bolt

Stop Bolt Location

68

Image 72
Contents Operator’s Manual Foreword Table of Contents Maintenance Schedule Chart Important Tips for Care General Information GlossaryIdentifying Number Locations Fill In By PurchaserServicing of Engine and Drivetrain Components Specifications EngineElectrical System TransmissionBlade Drive Tire SizeTire Pressure PSI KPA Dimensions Tractor and Mower Length in. cm Weight lb kgWidth in. cm Height in. cmMower Deck Drive BeltsSeat Component Identification Front View and Right Side ViewRear View and Left Side View Top View Body Raised Safety Instructions Before Operating Before OperatingDo not mow with bystanders in the area Safety Instructions Before Operating Safety Instructions Operating Safety Instructions Operating Safety Instructions Maintenance Safety Instructions Location Top of Fuel Tank Part NumberLocation Gearbox Cover Gear Drive Decks Only Part Number Location Chassis Member Behind Transaxles Part NumberLocation Each End of Mower Deck Part Number Location Deck Discharge Shield SD Decks Only Part NumberLocation Deck Gearbox Cover Part Number Location LH Fender Part Number Location RH Fender Part NumberAssembly Instructions Setup InstructionsBattery Service Battery Installation Battery Installation Mower Deck AssemblyDeck Caster Wheels Installation Batteries Produce Explosive GasesDeck Caster Wheel Installation Discharge Shield Installation On Side Discharge DeckPTO Shaft Guard Installation Deck Installation Mower Deck InstallationDeck Counterweight Spring Installation PTO Shaft ConnectionMachine must be shut off during this procedure Deck LevelingDeck Leveling Fill Fuel Tank Refer to Lubrication for Transaxle LubricationBlades in Maintenance Instructions Ignition Switch Key Positions Operating InstructionsControl IDENTIFICATION, LOCATION, and Function Engine ChokeEngine Throttle Choke and Throttle Location Forward Speed Control FSCSteering Levers Blade Clutch PTOParking Brake Hydro Lockout Arm LocationHourmeter Left Wheel Steering Leverright Wheel Operating Controls Top View from Drivers Point of ViewAdjusting Ground Speed and Steering Starting the EngineEngaged Forward Speed Control Friction Adjustment Beginning Recommendations areCorrect Operator Hand Position On the Controls Blade Clutch Engaged Stopping the MachineCutting Height Adjustment Transaxle LockoutsHydro Lockout Arm Freewheel Position Hydro Lockout Arm Normal Operating PositionRecommendations for Mowing Side Discharge Deflector Shield Lowest Position No Driving ZoneRecommendations for TILT-UP Deck OPERATION/TRANSPORT GHS Model Only GHS Flow and ComponentsGeneral Information Rotating Blower BladesClogging Checklist ForwardUsing the Tilt-Up Deck PowerfilFull Signal Horn Tailgate Dumping Using the Dump Bag Positioning Dump Bag on CatcherDumping Catcher into Dump Bag Maintenance Instructions Maintenance procedures requiring special training orService Item 100 400 Every HoursImportant Tips for Care of the Subaru Engine Lubrication Each USENot Screwed Oil Drain Location View from Lower Right Side of Tractor Grease Fitting and Oil Point LubricationDeck and Carrier Frame Illustrated Maintenance Instructions Mower Deck Gearbox Lubrication Transaxle LubricationExpansion Reservoir Location Guard Cleaning Air Cleaner Components Shown with Cover RemovedEngine Air Cleaner System Components Air Filter Element Replacement Proper Orientation of Air Cleaner Cover Fuel FilterFuel Filter and Fuel Shut-off Valve Location Keep Rotating Engine Cooling Air Intake Screen Clean Cooling Air Intake ScreenCooling System Airflow GHS Exhaust Screen Transaxle Housing Transaxle Housing and Cooling FinsBattery Transaxle Cooling FansCharging the Battery Tire PressureWheel Nut Torque Sharpen Mower BladesMower Blade Profile for Sharpening Blade Balanced on Magnetic Wall-Mounted BalancerDrive Belts Spark PlugIgnition Forward Speed Control Friction Lock REPLACING/REPAIRING Belt LocationsEngine Belt Engine Belt DisengagedEngine Belt Engaged PTO Drive Belt PTO Drive Belt DisengagedPTO Drive Belt Engaged Ground Drive Belt Assembly Disengaged Ground Drive Belt Assembly EngagedGround Drive Belt Blade Overload Shear Bolts Cutting Blade Shear BoltsPTO Shear Pin Mower Blades Adjustments Steering Lever Position AdjustmentTransmission Control Lever AlignmentSteering Handles Adjustment FSC Lever Position AdjustmentCorrect FSC Lever NEUTRAL-PARK Position Maintenance Instructions FSC Neutral Switch Location FSC Friction Adjustment Test FSC Friction Adjustment NutPTO Clutch Engaged PTO Clutch Disengaged Blade Brake Band Adjustment Blade Brake Band Adjustment Clutch Disengaged Adjusting the Grass-PakSwitch Pinch Point Spring Loaded DoorSide View of Catcher Box With a little advance warning before overfillingOperator’s Notes Operator’s Notes Limited Warranty For Walker Model S14 Rider Mower Walker MFG. CO E. Harmony ROAD, Fort COLLINS, CO 80528 970

S14 specifications

The Walker S14 is an innovative piece of technology designed to enhance mobility and independence for individuals facing mobility challenges. This advanced mobility device integrates cutting-edge features and technologies to deliver a safe and comfortable user experience.

One of the standout characteristics of the Walker S14 is its lightweight yet robust design. Constructed from high-quality materials, the walker provides durability without sacrificing portability. It can easily be maneuvered both indoors and outdoors, making it suitable for various environments.

A significant technological advancement in the Walker S14 is its adjustable height feature. Users can customize the walker to their preferred height, ensuring optimal support and reducing strain on the body. This feature is particularly beneficial for individuals with varying mobility needs, as it promotes a proper walking posture.

Safety is a top priority in the design of the Walker S14. It is equipped with a reliable braking system that enhances stability when stationary. The walker features ergonomic hand grips that provide comfort and reduce the risk of slipping. Additionally, its non-slip wheels are designed to provide a reliable grip on various surfaces, contributing to a safer walking experience.

In terms of storage and convenience, the Walker S14 includes a built-in storage pouch, allowing users to carry personal items or essential belongings. This feature is particularly useful for users who wish to maintain their independence while being able to access their belongings easily.

The Walker S14 is also praised for its sleek and modern aesthetic. With a variety of color options, users can choose a design that reflects their personality while still benefiting from the practicality of the mobility device.

Moreover, the Walker S14 is designed for easy folding and portability. Whether for storage or transport, users can quickly collapse the walker to fit it in tight spaces or vehicles without any hassle.

Overall, the Walker S14 combines innovative technology, user-centric design, and robust safety features to provide an unparalleled walking experience. It empowers individuals with mobility challenges to navigate their surroundings with confidence, fostering independence and a better quality of life.