Whirlwind WW60-10001 manual ST Extended Position, 2ND Extended Position, Caster WHEEL6 Attachments

ASSEMBLY

A-FRAME ATTACHMENT (cont'd.)

Install floating hitch pins to main frame using either the standard or extended hitch postions. See Figures 2 - 4 below for correct installation. Install hitch flats (1) to deck hitch using bolts (4) and locknuts (5), inserting bushings (2 & 3) in proper locations as shown in Figure 2. The hitch pin (6) is always to be located on end nearest to the tractor. There are two extended positions. To install in extended position move flats (1) forward and place bushings in the proper locations shown in Figures 3 & 4.

	5
8	1

3	2
		4
	8
	STANDARD POSITION	1ST EXTENDED POSITION
	FIGURE 2	FIGURE 3

2ND EXTENDED POSITION

ASSEMBLY

FIGURE 4

CASTER WHEEL6 ATTACHMENTS

Attach the right and left Axle Arm Weldment (1) to the deck with 3/8"

2

4

5

1

3

bolts (2) flatwasher (1-1/2" OD x 3/16" thick) (3), 7 lockwashers (4), and locknuts (5). Install a one inch spacer (6) and a 1/2 inch spacer (7) on each fork and wheel assembly shaft (8). Insert fork shaft into axle arm weldment. Install three additional one inch spacers (6) on each axle shaft and retain using snapper pin (9). FIGURE 4.

8

9

2

FIGURE 4

WHIRLWIND 08/01	Assembly Section 3-3
© 2004 Alamo Group Inc.