Whirlwind WW60-10001 manual Belt Adjustment Procedure Figure

Page 86

MAINTENANCE

BELT ADJUSTMENT PROCEDURE Figure 7.

Shut off mower and tractor. Loosen all four nuts (item 1) on gearbox slide plate (item 2). Loosen jam nut (item

3)on tension adjustment bolt (item 4). Tighten adjustment bolt until belt deflection along front of belts (item 5 & 6) is 3/4" with approximately 10 pounds applied to center of length. DO NOT OVERTIGHTEN. Tighten jam nut (item

3)and nuts (item 1) on bearbox slide plate.

3

4

2

1

MAINTENANCE

7

FIGURE 7

 

5

6

3/4"

8

3

BELT REMOVAL/INSTALLATION Figure 7.

Shut off mower and tractor. Remove belt shield fasteners and belt shields. Loosen gearbox slide plate bolts and gear box adjustment bolt. Slide gearbox to the full forward position. Slip belts under gearbox sheave (item 7) and over center spindle sheave (item 8). Slip new belts under gearbox sheave (item 7) and over center spindle sheave (item 8). Ensure that right-hand belt (item 6) is in the upper groove of gearbox sheave and that left-hand belt (item

5)is in the lower groove of gearbox sheave. Slide gearbox to the full rear position and adjust according to Belt Adjustment Procedure. Reinstall shields and shield fasteners.

WHIRLWIND 08/01

Maintenance Section 5-6

© 2004 Alamo Group Inc.

 

Image 86
Contents Whirlwind To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Safety Whirlwind 08/01¡LEA EL Instructivo SGM-11 SG-12 By the following rules Mowing All Safety Shields, Guards and Safety devices including Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life Parts Information See Your SERVIS-RHINO DealerQTY Level Description Not Shown See Inside Front Cover of Manual D103 WW72 Safety Federal Laws and Regulations DutiesPage Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Exceed Horsepower Recommendations Dealer SET-UP Instructions Frame AttachmentCaster WHEEL6 Attachments ST Extended Position2ND Extended Position Discharge Chute Installation Operation Section Tractor Preparation Attaching Mower to Tractor Lift TypeStarting & Stopping Cutter Cutting Height AdjustmentDriveline Attachment to Tractor Side Discharge Cutting SpeedCutting Tips Before Operating or Transporting this Mower Driveline Length Check ProcedureDetaching and Storing Colored TapeDriveline Length Front Gauge Wheel Interference CheckProblem Possible Cause Remedy Damaged Belt Belt SlippageBelt Rollover Belt BreakageMaintenance Section Description Frequency Lubrication InformationLubrication Fitting Location Gearbox Gauge Wheel AssembliesDriveline Lubrication Blade Spindle LubricationBlade Sharpening Blade InstallationBlade Servicing Follow Original Pattern Maintain CornerBelt Adjustment Procedure Figure Storage Proper Torque for FastenersDisassembly AssemblyPage SERVIS-RHINO Required of the Owner Required of the OperatorMODEL-OMWPL-08/01 RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy