Whirlwind WW60-10001 manual Storage, Proper Torque for Fasteners

Page 87

MAINTENANCE

STORAGE

Your rotary mower represents an investment from which you should get the greatest possible benefit. Therefore, when the season is over, the cutter should be thoroughly checked and prepared for storage so that a minimum amount of work will be required to put it back into operation for the next season. The following are suggested storage procedures:

1.Thoroughly clean the cutter.

2.Lubricate the cutter as covered in Maintenance Section.

3.Tighten all bolts and pins to the recommended torque.

4.Check the cutter for worn or damaged parts. Make replacements immediately.

5.Store the cutter in a clean, dry place with the cutter housing resting on blocks.

6.Use spray touch-up enamel where necessary to prevent rust and maintain the appearance of the cutter.

PROPER TORQUE FOR FASTENERS

The chart lists the correct tightening torque for fasteners. When bolts are to be tightened or replaced, refer to this chart to determine the grade of bolts and the proper torque except when specific torque values are assigned in manual text.

RECOMMENDED TORQUE IN FOOT POUNDS UNLESS OTHERWISE STATED IN THE MANUAL*

NOTE: These values apply to fasteners as received from supplier, dry or when lubricated with normal engine oil. They do not apply if special graphited or molydisulphide greases or other extreme pressure lubricants are used. This applies to both UNF fine and UNC coarse threads.

*

WHIRLWIND 08/01	Maintenance Section 5-7
© 2004 Alamo Group Inc.

MAINTENANCE

Image 87

Contents Whirlwind To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Whirlwind 08/01 Safety¡LEA EL Instructivo SGM-11 SG-12 By the following rules Mowing All Safety Shields, Guards and Safety devices including Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life See Your SERVIS-RHINO Dealer Parts InformationQTY Level Description Not Shown See Inside Front Cover of Manual D103 WW72 Duties Safety Federal Laws and RegulationsPage Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Frame Attachment Exceed Horsepower Recommendations Dealer SET-UP InstructionsST Extended Position 2ND Extended PositionCaster WHEEL6 Attachments Discharge Chute Installation Operation Section Attaching Mower to Tractor Lift Type Tractor PreparationCutting Height Adjustment Driveline Attachment to TractorStarting & Stopping Cutter Cutting Speed Cutting TipsSide Discharge Colored Tape Driveline Length Check ProcedureDetaching and Storing Before Operating or Transporting this MowerFront Gauge Wheel Interference Check Driveline LengthProblem Possible Cause Remedy Belt Breakage Belt SlippageBelt Rollover Damaged BeltMaintenance Section Lubrication Information Lubrication Fitting LocationDescription Frequency Gauge Wheel Assemblies GearboxBlade Spindle Lubrication Driveline LubricationFollow Original Pattern Maintain Corner Blade InstallationBlade Servicing Blade SharpeningBelt Adjustment Procedure Figure Proper Torque for Fasteners StorageAssembly DisassemblyPage SERVIS-RHINO Required of the Operator Required of the OwnerMODEL-OMWPL-08/01 RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy