Whirlwind WW60-10001 manual Gearbox, Gauge Wheel Assemblies

Page 83

MAINTENANCE

GEARBOX

The Gearboxes have been filled with lubricant to the Test Plug Level prior to shipment. However, you should check the oil level at Test Plug before operating, and frequently thereafter.

The gearbox should not require additional lubricant unless the box is cracked or a seal is leaking. It is recommended that the oil level plug be removed after every 8 to 10 hours of operation and oil added until it runs out Test Plug hole. The Test Plug is located on the back of the Gearbox. Filler Plug is located on top back of Gearbox. Figure 2.

BREATHER/FILLER

PLUG

FIGURE 2

TEST PLUG

Recommended lubricant is NLGI 000 Grease, Rhino P/N 00765444. The Gearbox has a capacity of one quart.

NOTE: Overfilling the Gearbox will cause pressure to build up and cause Oil Seals to leak.

ATTENTION: If the Gearbox suddenly starts making an unusual noise, stop at once, check for leaks, and refill Gearbox as required.

GAUGE WHEEL ASSEMBLIES

Gauge wheels are equipped with bushings which require grease dai- ly. Grease Fittings are provided in the Wheel Hub and Gauge Wheel Pivot . Grease after 8 hours of use. FIGURE 3 &4.

	FIGURE 3	FIGURE 4
WHIRLWIND 08/01	Maintenance Section	5-3
© 2004 Alamo Group Inc.

MAINTENANCE

Image 83

Contents Whirlwind To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Whirlwind 08/01 Safety¡LEA EL Instructivo SGM-11 SG-12 By the following rules Mowing All Safety Shields, Guards and Safety devices including Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life See Your SERVIS-RHINO Dealer Parts InformationQTY Level Description Not Shown See Inside Front Cover of Manual D103 WW72 Duties Safety Federal Laws and RegulationsPage Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Frame Attachment Exceed Horsepower Recommendations Dealer SET-UP InstructionsCaster WHEEL6 Attachments ST Extended Position2ND Extended Position Discharge Chute Installation Operation Section Attaching Mower to Tractor Lift Type Tractor PreparationStarting & Stopping Cutter Cutting Height AdjustmentDriveline Attachment to Tractor Side Discharge Cutting SpeedCutting Tips Colored Tape Driveline Length Check ProcedureDetaching and Storing Before Operating or Transporting this MowerFront Gauge Wheel Interference Check Driveline LengthProblem Possible Cause Remedy Belt Breakage Belt SlippageBelt Rollover Damaged BeltMaintenance Section Description Frequency Lubrication InformationLubrication Fitting Location Gauge Wheel Assemblies GearboxBlade Spindle Lubrication Driveline LubricationFollow Original Pattern Maintain Corner Blade InstallationBlade Servicing Blade SharpeningBelt Adjustment Procedure Figure Proper Torque for Fasteners StorageAssembly DisassemblyPage SERVIS-RHINO Required of the Operator Required of the OwnerMODEL-OMWPL-08/01 RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy