Whirlwind WW60-10001 manual Driveline Lubrication, Blade Spindle Lubrication

Page 84

MAINTENANCE

MAINTENANCE

DRIVELINE LUBRICATION

Grease Fittings are located on the Cross Assembly of each U-Joint and on the telescoping tubes. Grease the U-Joint after each 8 hours of use. Figure 4. Do not force grease through the Needle Cup Assemblies.

FIGURE 4

The telescoping PTO shaft inside the shielding must be lubricated daily. Figure 5.

Disconnect driveline from tractor and pull halves apart. Insert grease into outer profile cavity on half attached to gearbox and spread evenly. Install driveline halves together.

Reconnect driveline to tractor. Raise and lower cutter after applying grease to spread over joint working area.

FIGURE 5

WARNING! When attaching PTO yoke to tractor PTO shaft, it is important that the spring-activated locking twist collar rotates freely and locking ball are seated on the groove on PTO shaft. A loose yoke could slip off and result in personal injury or damage to cutter.

BLADE SPINDLE LUBRICATION

Blade spindles must be lubricated daily (every 8 hrs). Access lubrication fitting through hole in outer sheilds and in center gearbox mounting. Each spindle has vent hole in top just under drive pulley and must be lubricated enough each time to force small amount of grease out. NOTE: Do not over lube as excess grease may get on belt drive.

WHIRLWIND 08/01	Maintenance Section 5-4
© 2004 Alamo Group Inc.

Image 84

Contents Whirlwind To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Safety Whirlwind 08/01¡LEA EL Instructivo SGM-11 SG-12 By the following rules Mowing All Safety Shields, Guards and Safety devices including Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life Parts Information See Your SERVIS-RHINO DealerQTY Level Description Not Shown See Inside Front Cover of Manual D103 WW72 Safety Federal Laws and Regulations DutiesPage Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Exceed Horsepower Recommendations Dealer SET-UP Instructions Frame AttachmentST Extended Position 2ND Extended PositionCaster WHEEL6 Attachments Discharge Chute Installation Operation Section Tractor Preparation Attaching Mower to Tractor Lift TypeCutting Height Adjustment Driveline Attachment to TractorStarting & Stopping Cutter Cutting Speed Cutting TipsSide Discharge Driveline Length Check Procedure Detaching and StoringBefore Operating or Transporting this Mower Colored TapeDriveline Length Front Gauge Wheel Interference CheckProblem Possible Cause Remedy Belt Slippage Belt RolloverDamaged Belt Belt BreakageMaintenance Section Lubrication Information Lubrication Fitting LocationDescription Frequency Gearbox Gauge Wheel AssembliesDriveline Lubrication Blade Spindle LubricationBlade Installation Blade ServicingBlade Sharpening Follow Original Pattern Maintain CornerBelt Adjustment Procedure Figure Storage Proper Torque for FastenersDisassembly AssemblyPage SERVIS-RHINO Required of the Owner Required of the OperatorMODEL-OMWPL-08/01 RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy