Whirlwind WW60-10001 manual Detaching and Storing, Before Operating or Transporting this Mower

Page 77

OPERATION

DETACHING AND STORING

Lower the Mower to the Ground. Park the Tractor with the transmission in the correct gear (Automatic Transmission--Park; Standard Transmission-- Neutral). Set the parking brake, shut off the engine, and remove the key, Wait until the PTO stops rotating before getting down from the tractor.

Disconnect the driveline from the tractor PTO and store it to prevent it from contacting the ground.

Always reinstall the Master Shield over the tractor PTO Shaft. This shield should always remain in place except when connecting or disconnecting driveline.

FIGURE 2

BEFORE OPERATING OR TRANSPORTING THIS MOWER

Always display this SMV emblem (FIGURE 2) on the rear of the tractor transporting this mower where it is clearly visible to oncoming traffic. Prominent display of this symbol will help the operator avoid accidents which could cause injury or possibly death.

DRIVELINE LENGTH CHECK PROCEDURE

WARNING! A loose shaft could slip off and result in personal injury or dfamage to cutter. When attaching PTO yoke to tractor PTO shaft, it is important that spring activated locking collar slides freely and locking balls are seated in groove on PTO shaft.

WARNING! Before operating cutter, check to make sure the driveline will not bottom out or become disengage.

* Disengage the Driveline from the tractor PTO Shaft.

* Slide the Driveline together until it "bottoms out" solidly.

1/8 INCH

*Apply colored tape to the Inner Shield 1/8" from the end of the Outer Shield. FIGURE 3

*Re-attach the Driveline to the PTO Shaft.

COLORED TAPE

FIGURE 3

Driveline in maximum compressed position

WHIRLWIND 08/01

Operation Section 4-5

© 2004 Alamo Group Inc.

 

OPERATION

Page 76 Page 78
Image 77
Page 76 Page 78
Contents Whirlwind To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Whirlwind 08/01 Safety¡LEA EL Instructivo SGM-11 SG-12 By the following rules Mowing All Safety Shields, Guards and Safety devices including Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life See Your SERVIS-RHINO Dealer Parts InformationQTY Level Description Not Shown See Inside Front Cover of Manual D103 WW72 Duties Safety Federal Laws and RegulationsPage Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Frame Attachment Exceed Horsepower Recommendations Dealer SET-UP InstructionsCaster WHEEL6 Attachments ST Extended Position2ND Extended Position Discharge Chute Installation Operation Section Attaching Mower to Tractor Lift Type Tractor PreparationStarting & Stopping Cutter Cutting Height AdjustmentDriveline Attachment to Tractor Side Discharge Cutting SpeedCutting Tips Detaching and Storing Driveline Length Check ProcedureBefore Operating or Transporting this Mower Colored TapeFront Gauge Wheel Interference Check Driveline LengthProblem Possible Cause Remedy Belt Rollover Belt SlippageDamaged Belt Belt BreakageMaintenance Section Description Frequency Lubrication InformationLubrication Fitting Location Gauge Wheel Assemblies GearboxBlade Spindle Lubrication Driveline LubricationBlade Servicing Blade InstallationBlade Sharpening Follow Original Pattern Maintain CornerBelt Adjustment Procedure Figure Proper Torque for Fasteners StorageAssembly DisassemblyPage SERVIS-RHINO Required of the Operator Required of the OwnerMODEL-OMWPL-08/01 RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy
Top Page Image Contents