ASSEMBLY
ASSEMBLY
The Whirlwind Mowers will attach to most tractors with Cat. I
EXCEED HORSEPOWER RECOMMENDATIONS.
DANGER! Operating with PTO speed over 540 RPM can cause excessive vibration with subsequent machine failure which can cause serious injury or even death. Never exceed 600 RPM.
DEALER SET-UP INSTRUCTIONS
Assembly of this mower is the reponsibility of the Rhino dealer. The mower should be delivered to the owner completely assembled, lubricated, and adjusted for normal cutting conditions.
Set up mower as received from the factory with these instructions. Remove mower from carton. Open parts box and lay parts out to make location easy. Refer to parts lists and exploded view drawings for more detail.
This mower is shipped partially assembled. Assembly will be easier if components are aligned and loosely assembled before tightening hardware.
CAUTION! Always use personal protection devices such as eye and ear protectors during assembly.
A-FRAME ATTACHMENT
12
8 9
10
7
11
4 
6
Attach the rear brace bars (1) to the lugs on the rear of the deck with 1/2" x
(11)is placed through the open end set of holes of the top link and secured with hair clip pin (12). See FIGURE 1.
1
3
2
FIGURE 1
5
WHIRLWIND 08/01 | Assembly Section |
© 2004 Alamo Group Inc. |
|