Whirlwind WW60-10001 manual Driveline Length, Front Gauge Wheel Interference Check

Page 78

OPERATION

OPERATION

DRIVELINE LENGTH

Raise mower to full transport or until driveline just hits deck at front. If distance between colored tape and outer

shield tube is 1-9/16 or less, drive tubes should be shortened per Figure 4.

always maintain 1-9/16 clearance when operated in shortest working position. shorten inner and outer guard tubes equally. Shorten inner and outer sliding profiles by the same amount that the shield tubes were short- ened. Round off all sharp edges and remove burrs. Grease sliding profiles. Figure 4.

1-9/16"

FIGURE 4

Lower mower to lowest position possible. Check distance from colored tape to end outer shield tube. Drive- line tube engagement must always exceed 12 inches. If not consult dealer to obtain longer driveline.

FRONT GAUGE WHEEL INTERFERENCE CHECK

Do not operate mower until this interference check has been performed. If you change tractors, you must perform the check for that mounting.

Raise mower with tractor hydraulics to maximum height of tractor lift.

Pivot both front gauge wheels forward and check that there is clearance between gauge wheels and tractor tires.

If there is interference, you must move hitch pin to extended position (See assembly section). Move tractor tires inward to obtain clearance or lower mower until clearance exists. Set 3-Point quadrant stop so mower cannot be raised beyond set point. FIGURE 5.

	Figure 5 - Front Gauge Wheel Clearance
WHIRLWIND 08/01	Operation Section 4-6
© 2004 Alamo Group Inc.

Image 78

Contents Whirlwind To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Safety Whirlwind 08/01¡LEA EL Instructivo SGM-11 SG-12 By the following rules Mowing All Safety Shields, Guards and Safety devices including Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life Parts Information See Your SERVIS-RHINO DealerQTY Level Description Not Shown See Inside Front Cover of Manual D103 WW72 Safety Federal Laws and Regulations DutiesPage Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Exceed Horsepower Recommendations Dealer SET-UP Instructions Frame AttachmentST Extended Position 2ND Extended PositionCaster WHEEL6 Attachments Discharge Chute Installation Operation Section Tractor Preparation Attaching Mower to Tractor Lift TypeCutting Height Adjustment Driveline Attachment to TractorStarting & Stopping Cutter Cutting Speed Cutting TipsSide Discharge Before Operating or Transporting this Mower Driveline Length Check ProcedureDetaching and Storing Colored TapeDriveline Length Front Gauge Wheel Interference CheckProblem Possible Cause Remedy Damaged Belt Belt SlippageBelt Rollover Belt BreakageMaintenance Section Lubrication Information Lubrication Fitting LocationDescription Frequency Gearbox Gauge Wheel AssembliesDriveline Lubrication Blade Spindle LubricationBlade Sharpening Blade InstallationBlade Servicing Follow Original Pattern Maintain CornerBelt Adjustment Procedure Figure Storage Proper Torque for FastenersDisassembly AssemblyPage SERVIS-RHINO Required of the Owner Required of the OperatorMODEL-OMWPL-08/01 RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy