Whirlwind WW60-10001 Lubrication Information, Lubrication Fitting Location, Description Frequency

Page 82

MAINTENANCE

MAINTENANCE

Before operating your Finishing Mower, make sure it is properly lubricated and thoroughy inspected. Only a minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and trouble free operation.

WARNING! Always disengage the PTO before raising the Rotary Cutter for transporting or making adjustments.

LUBRICATION INFORMATION

Do not let excess grease collect on or around parts, particulary when operating in sandy areas. The illustrations below shows lubrication points. The chart gives the frequency of lubrication in hours, based on normal operating conditions. Severe or unusual conditions may require more frequent lubrication. Figure 1.

Use an SAE multi-purpose, lithium-type grease for all locations shown. Be sure to clean the fitting thoroughly before using grease gun. Failure to maintain proper lubrication will result in damage to U-joints, gearbox, and/or driveshaft.

3
4
1
	5	3
5	5
5
2
	3
	LUBRICATION FITTING LOCATION FIGURE1
ITEM	DESCRIPTION	FREQUENCY
1	Gauge Wheel Pivots	8 Hours or daily
2	Wheel Hubs	8 Hours or daily
3	Blade Spindle	8 Hours or daily
4	U-Joint Telescoping Member	8 Hours or daily
5	U-Joints	8 Hoursor daily
WHIRLWIND 08/01	Maintenance Section 5-2
© 2004 Alamo Group Inc.

Image 82

Contents Whirlwind To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Safety Whirlwind 08/01¡LEA EL Instructivo SGM-11 SG-12 By the following rules Mowing All Safety Shields, Guards and Safety devices including Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life Parts Information See Your SERVIS-RHINO DealerQTY Level Description Not Shown See Inside Front Cover of Manual D103 WW72 Safety Federal Laws and Regulations DutiesPage Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Exceed Horsepower Recommendations Dealer SET-UP Instructions Frame Attachment2ND Extended Position ST Extended PositionCaster WHEEL6 Attachments Discharge Chute Installation Operation Section Tractor Preparation Attaching Mower to Tractor Lift TypeDriveline Attachment to Tractor Cutting Height AdjustmentStarting & Stopping Cutter Cutting Tips Cutting SpeedSide Discharge Before Operating or Transporting this Mower Driveline Length Check ProcedureDetaching and Storing Colored TapeDriveline Length Front Gauge Wheel Interference CheckProblem Possible Cause Remedy Damaged Belt Belt SlippageBelt Rollover Belt BreakageMaintenance Section Lubrication Fitting Location Lubrication InformationDescription Frequency Gearbox Gauge Wheel AssembliesDriveline Lubrication Blade Spindle LubricationBlade Sharpening Blade InstallationBlade Servicing Follow Original Pattern Maintain CornerBelt Adjustment Procedure Figure Storage Proper Torque for FastenersDisassembly AssemblyPage SERVIS-RHINO Required of the Owner Required of the OperatorMODEL-OMWPL-08/01 RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy