Woods Equipment LU126 installation manual Hose Kit Verify Control Movements

58025 Hose Kit

Verify Control Movements
1.	Mount loader to tractor: Remove mount pins
	from loader uprights. Align tractor with loader and
	slowly drive tractor into loader. Shut off tractor.
2.	Connect loader feedline hoses to tractor remote
	control couplers. See Figure 9.
					Control 2
3.				Control 1
	Comply with all safety rules and start the tractor.
4.	Mount loader to tractor by activating bucket
	cylinders to raise or lower the loader uprights into
	the loader mounts. Slowly advance tractor
	forward, activating appropriate cylinders to
	engage loader completely into mounts. Insert				CM1570
	mounting pins to secure loader.
5.	Check that all hydraulic control lever positions
	operate the loader movements correctly as
	shown in Figure 12.
6.	If loader movements do not respond correctly,
	shut off tractor, relieve pressure, and reconnect
	properly. Loader control movements must be
	correct before proceeding.
7.	Once all loader functions are correct, start the
	tractor and operate the loader to check for leaks.
	Purge any remaining air from the hydraulic
	system and check oil level.				DP1
8.	When hose routings and correct loader
	operations are verified, identify each circuit by	●	Control 1, Handle forward - Boom down
	placing a matching colored band around the male
		●	Control 1, Handle back - Boom up
	and female quick couplers. The color-coded
		●	Control 2, Handle forward - Dump bucket
	bands will make reinstallation easier when the
			or attachment
	loader is removed from tractor.
		●	Control 2, Handle back - Rollback bucket
9.	Be sure that adequate slack is left in the hoses so
			or attachment
	they can move as the loader moves through its
	full range of motion.	Figure 12. Tractor Hydraulic Control Levers

10.Attach the plastic tie straps (included in kit) every 20-inches around the hoses to keep them tightly bundled and away from contact with the ground or other moving parts on the tractor or loader.

11.Before operating the loader, make sure that the Pre-Delivery, Delivery, and Pre-Operation Checklists from the Operator section in the Loader Operator’s Manual have been completed.

10 Hydraulic Installation MAN0041 (Rev. 4/4/2008)