Woods Equipment LU126 installation manual Install Hydraulic Fitting to Tractor Valve

1010460 HOSE KIT

General Description

These set-up instructions are for operating the 1020, 1027 loader using the tractor hydraulic remote control lever. To use this hydraulic connection, the tractor must be equipped with a multi-function hydraulic con- trol valve and remote control lever. The control valve is located on the right side of the tractor beneath the operator platform.

NOTE: After the hydraulics and loader are installed on the tractor, check the clearance between the top of the exhaust pipe and the loader boom when the loader is raised. If there is interference, a weather cap will need to be installed. See Page 6 for installation instructions.

Figure 24. Tractor Hydraulic Control Lever and Valve

Install Hydraulic Fitting to Tractor Valve

1.	Locate the tractor hydraulic valve under the right	1.	1010920	Adapter, M22 x 1.5 x 3/4 JICM
	side of the tractor platform.	3.	315036	Adapter, 3/8 NPTM x 3/4 JICF
2.	Install adapters (1), adapter (3), and female half	5.	316007	Quick coupler set, male & female

of quick coupler set (5) to each of the tractor valve ports. See Figure 7 and Figure 8.

NOTE: Not all parts supplied with this hose kit are used for this application.

Figure 25. Hydraulic Fittings Installed Figure 26. Hydraulic Fitting Installation

16 Hydraulic Installation MAN0041 (Rev. 4/4/2008)