Woods Equipment LU126 installation manual Torque Hardware, Install Weather Cap on Exhaust Pipe

Torque Hardware					NOTICE
Torque all hardware to specifications listed below.				■ Check torque value of mount hardware after
				10 hours of operation and again after every 50
				hours of operation.
		TORQUE SPECIFICATIONS
	Ref.	Cap Screw	Qty	Wrench	Required Torque
				Size
	7	M20 x 2.5P x 40 mm	2	30 mm	244 lbs-ft. (330 N-m)
	5	M20 x 2.5P x 50 mm	8	30 mm	244 lbs-ft. (330 N-m)
	8	M20 x 2.5P x 70 mm	4	30 mm	244 lbs-ft. (330 N-m)

Install Weather Cap on Exhaust Pipe

NOTE: After the hydraulics and loader are install on the tractor, check the clearance between the top of the exhaust pipe and the loader boom when the loader is raised. If there is interference, a weather cap will need to be installed.

1.Remove exhaust pipe from the tractor. Save hardware for later use.

2.Remove approximately 6-inches from the top of the exhaust pipe.

3.Attach exhaust pipe to the tractor. Make sure that the support flange on the exhaust pipe is between the tractor and the support bracket as shown in page 6. Secure using hardware previously removed.

4.Attach weather cap to the top of the exhaust pipe with supplied hardware. Position cap hinge to the rear. See Figure 5. Weather cap is included in the loader mount kit.

DP7

Figure 4. Exhaust Pipe Reinstalled

Forward

DP8

Figure 5. Weather Cap Installed

6 Mount Installation MAN0041 (Rev. 4/4/2008)