Woods Equipment Comprehensive Loader Mount Installation Guide for Woods Loader Parts

LOADER MOUNT INSTALLATION

CAUTION

■Only use 111874 Loader Mounting Kit for

mounting Woods LU126, LU132, 1020, 1027 loaders on New Holland® TN55, TN60A TN65, TN70, TN70A, TN75, TN75A tractors and Case IH® JX1060C, JX1070C, and JX1075C tractors. Any other use or modification of this mounting kit may result in seri- ous injury or death.

„Safety instructions are important! Read all attachment and power unit manuals; follow all safety rules and safety decal information. (Replace- ment manuals and safety decals are available from your dealer. To locate your nearest dealer, check the Dealer Locator at www.WoodsEquipment.com, or in the United States and Canada call 1-800-319- 6637.) Failure to follow instructions or safety rules can result in serious injury or death.

„Do not modify or alter or permit anyone else to modify or alter the equipment or any of its compo- nents in any way.

„Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hair, hands, hearing, and head; and respirator or filter mask where appropriate.

„If you do not understand any part of this manual and need assistance, see your dealer.

NOTICE

■This equipment must be assembled and installed on the customer’s tractor by the Woods dealer. Dealer must thoroughly inspect equipment and complete each item on the PRE-DELIVERY CHECK LIST, DELIVERY CHECK LIST, and PROD- UCT REGISTRATION from the loader manual before equipment is released to the customer.

Tractor Preparation	NOTICE
For installing this mounting kit, references to right, left,	■ Clean threaded holes in the tractor chassis
forward, and rearward directions are determined from	thoroughly, using a tap of the proper size. Paint,
the operator’s position in the tractor seat.	rust, or debris in the threads may not permit cap
1. Remove the tractor front weights and front fend-	screws to be installed and tightened correctly.
ers, if equipped.
2. Rotate the exhaust pipe opening to face away
from the left side of the tractor.
NOTE: On TNA models the tip of the exhaust
pipe will have to be removed and a weather cap
installed. See page 6 for installation instructions.
3. Set the tractor wheels to the manufacturer’s
widest recommended spacing. Refer to the
tractor operator’s manual.

As a valued customer, Woods appreciates your comments. Once loader mount and hydraulic hoses have been installed, please take a few minutes to complete the Loader Mount Evaluation sheet that was supplied with this mount. Your comments will help us continue to bring you quality products.

4 Mount Installation MAN0041 (Rev. 4/4/2008)