HOSE KIT INSTALLATION
Keep hands and body away from pressurized lines. Use paper or cardboard, not hands or other body parts to check for leaks. Wear safety goggles. Hydraulic fluid under pressure can easily penetrate skin and will cause serious injury or death.
Make sure that all operating and service person- nel know that if hydraulic fluid penetrates skin, it must be surgically removed as soon as possible by a doctor familiar with this form of injury or gan- grene, serious injury, or death will result. CON-
TACT A PHYSICIAN IMMEDIATELY IF FLUID ENTERS SKIN OR EYES. DO NOT DELAY.
Air in hydraulic systems can cause erratic oper- ation and allows loads or equipment components to drop unexpectedly. When connecting equipment or hoses or performing any hydraulic maintenance, purge any air in hydraulic system by operating all hydraulic functions several times. Do this before putting into service or allowing anyone to approach the equipment.
Protective hose sleeves must cover all hydrau- lic hoses within 20 inches of the operator and be secured onto metal hose fittings. Replace hoses or sleeves if damaged or if protective sleeve cannot be properly positioned or secured.
Make sure all hydraulic hoses, fittings, and valves are in good condition and not leaking before starting power unit or using equipment. Check and route hoses carefully to prevent damage. Hoses must not be twisted, bent sharply, kinked, frayed, pinched, or come into contact with any moving parts. Operate moveable components through full operational range to check clearances. Replace any damaged hoses immediately.
58025 Hose Kit Installation - - - - - - - - - - - - - - Page 7 46945 Hose Kit Installation- - - - - - - - - - - - - - Page 11 1010460 Hose Kit Installation - - - - - - - - - - - - Page 16 1023577 Hose Kit Installation - - - - - - - - - - - - Page 19 1023584 Hose Kit Installation - - - - - - - - - - - - Page 22 1023583 Hose Kit Installation - - - - - - - - - - - - Page 24
58025 HOSE KIT
General Description
These set up instructions are for operating the 1020, 1027 loader using the tractor hydraulic remote control levers. To use this hydraulic connection the tractor must be equipped with either two hydraulic levers or a joystick control and four tractor hydraulic couplers as shown (Figure 5).
Hydraulic quick couplers for connection to tractor are NOT INCLUDED with hose kits, but are available as service parts.
NOTE: After the hydraulics and loader are installed on the tractor, check the clearance between the top of the exhaust pipe and the loader boom when the loader is raised. If there is interference, a weather cap will need to be installed. See Page 6 for installation instructions.
Figure 6. Connections to Tractor Hydraulic Couplers
(Typical)
MAN0041 (Rev. 4/4/2008) | Hydraulic Installation 7 |
|
|