1023582 HOSE KIT
General Description
These set up instructions are for operating the LU126 loader using a single lever control valve mounted to the right loader mount bracket as shown in Figure 21. To use this hydraulic connection, hose kit 1023582 must be connected between loader control valve and tractor hydraulics.
Install loader control valve before proceeding.
NOTICE
■If hydraulic lines are not connected as shown in this manual, the control valve may be damaged. A blocked outlet (RETURN) or improper hose con- nection will cause pressurized oil to enter the return circuit and damage the valve.
DP8
Figure 21. Control Valve Installed
Install Adapter Plate
NOTICE
■Removal of the accessory plate or remote valves with a load being held on the
Before attempting to install this kit, the following must be observed:
●Shut off engine, place transmission in neutral, and apply parking brake.
●Fully lower any equipment supported by the trac- tor remote hydraulic valves, if so equipped. Acti- vate any remote valves to relieve all hydraulic pressure in the remote circuits.
●Fully lower the
1.Thoroughly clean the top front of the hydraulic accessory plate.
2.Install elbow (12) and adapter (21) to adapter plate (2).
3.Remove accessory plate cover (A). Be careful not to disturb the
4.Install
5.Place the adapter plate over hydraulic opening.
6.Place the accessory plate cover onto the adapter plate. Make sure
7.Secure with hex head cap screws and flat washer as shown in Figure 22.
Figure 22. Adapter Plate Installed
A.
2.1001421 Adapter plate
10. 1001423 7/16 NC X
12.316004 Elbow, 3/4 JICM x 3/4 ORBM 90°
15.21549 7/16 NC x 3 HHCS
16.21548 5/16 NC x
19.4378 5/16 Standard flat washer
21.61 Adapter, 3/4 JICM x 3/4 ORBM
16 Hydraulic Installation | MAN0064 (Rev. 7/20/2007) |
|
|