HOSE KIT INSTALLATION
Keep hands and body away from pressurized lines. Use paper or cardboard, not hands or other body parts to check for leaks. Wear safety goggles. Hydraulic fluid under pressure can easily penetrate skin and will cause serious injury or death.
Make sure that all operating and service person- nel know that if hydraulic fluid penetrates skin, it must be surgically removed as soon as possible by a doctor familiar with this form of injury or gan- grene, serious injury, or death will result. CON-
TACT A PHYSICIAN IMMEDIATELY IF FLUID ENTERS SKIN OR EYES. DO NOT DELAY.
Air in hydraulic systems can cause erratic oper- ation and allows loads or equipment components to drop unexpectedly. When connecting equipment or hoses or performing any hydraulic maintenance, purge any air in hydraulic system by operating all hydraulic functions several times. Do this before putting into service or allowing anyone to approach the equipment.
Protective hose sleeves must cover all hydrau- lic hoses within 20 inches of the operator and be secured onto metal hose fittings. Replace hoses or sleeves if damaged or if protective sleeve cannot be properly positioned or secured.
Make sure all hydraulic hoses, fittings, and valves are in good condition and not leaking before starting power unit or using equipment. Check and route hoses carefully to prevent damage. Hoses must not be twisted, bent sharply, kinked, frayed, pinched, or come into contact with any moving parts. Operate moveable components through full operational range to check clearances. Replace any damaged hoses immediately.
57923 Hose Kit Installation - - - - - - - - - - - - - - page 9 1001420 Hose Kit Installation - - - - - - - - - - - - page 12 1023582 Hose Kit Installation - - - - - - - - - - - - page 16 1023596 Hose Kit Installation - - - - - - - - - - - - page 19
57923 HOSE KIT
General Description | Install Hose Fittings | |||
These instructions are for operating the 1020/1027 | 1. Attach elbow (2) and male quick coupler (3) to | |||
loader using the tractor hydraulic remote control lever. | each loader supply hose (1). | |||
To use this hydraulic connection, the tractor must be | 2. Connect loader supply hoses to loader steel | |||
equipped with two hydraulic levers and four tractor | ||||
feedlines following pattern shown in Figure 8. | ||||
hydraulic couplers. | ||||
1. | 57912 | Hose, 120" x 1/2 JICM x JICM | ||
NOTE: Male quick couplers (3) for connection to trac- | ||||
2. | 313053 | Elbow, 3/4 JICF x 1/2 NPTM | ||
tor are NOT included with the hose kit but are avail- | ||||
3. | 66511 | Quick coupler, male 1/2 | ||
able as service parts. | ||||
|
|
| ||
Figure 8. 1020/1027 Loader Supply Hose Connection
MAN0064 (Rev. 7/20/2007) | Hydraulic Installation 9 |
|
|