Woods Equipment 111877 Hydraulic Installation, Hose Kit, Install Adapter Plate, to enter the

1001420 HOSE KIT

General Description

These set-up instructions are for operating the 1020/1027 loader using a single-lever control mounted on the right loader upright as shown Figure

13.To use this hydraulic connection, hose kit 1001420 must be connected between loader control valve and tractor hydraulics.

Install control valve before proceeding.

NOTICE

■If hydraulic lines are not connected as shown in this manual, the control valve may be damaged. A blocked outlet (RETURN) or improper hose con-

nection will cause pressurized oil	to enter the
		Figure 13. 2-Spool Control Valve Installed (Typical)
return circuit and damage the valve.

Install Adapter Plate

NOTICE

■Removal of the accessory plate or remote valves with a load being held on the 3-point hitch will result in escape of high pressure oil and sud- den, uncontrolled drop of 3-point hitch arms.

Before attempting to install this kit, the following must be observed:

●Shut off engine, place transmission in neutral, and apply parking brake.

●Fully lower any equipment supported by the trac- tor remote hydraulic valves, if so equipped. Acti- vate any remote valves to relieve all hydraulic pressure in the remote circuits.

●Fully lower the 3-point hitch.

1.Thoroughly clean the top front of the hydraulic accessory plate.

2.Install elbows (1) and (2) to adapter plate (3).

3.Remove accessory plate cover (A). Be careful not to disturb the O-rings that need to stay with the cover plate when it is removed.

4.Install O-rings to bottom of adapter plate (3). Use petroleum jelly to keep the O-rings in the counterbores.

5.Place the adapter plate over hydraulic opening.

6.Place the accessory plate cover onto the adapter plate. Make sure O-rings stay in the counterbores.

7.Secure with hex head cap screws and flat washer as shown in Figure 14.

8.Secure elbows (1) and (2) as shown.

15	13	A
	11
		14
1
		3
	2	1

Figure 14. Adapter Plate Installed

A.----- Accessory plate cover

1.316004 Elbow, 3/4 JICM x 3/4 ORBM 90°

2.313032 Elbow, 3/4 JICM x 3/4 JICF 90°

3.1001421 Adapter plate

11.4378 5/16 Standard flat washer

13.21548 5/16 NC x 3-1/4 HHCS

14.21549 7/16 NC x 3 HHCS

15.1001423 7/16 NC x 4-3/4 HHCS

12 Hydraulic Installation MAN0064 (Rev. 7/20/2007)