LOADER MOUNT INSTALLATION
CAUTION
■Only use 111877 Loader Mounting Kit for mounting Woods 1020, 1027, LU126 loaders on Ford New Holland 2000, 2310, 2600, 2610, 2810, 2910, 3000, 3600, 3610, 3910, 4000SU, 4100, 4600SU, and 4610SU tractors. Any other use or modification of this mounting kit may result in seri- ous injury or death.
Safety instructions are important! Read all attachment and power unit manuals; follow all safety rules and safety decal information. (Replace- ment manuals and safety decals are available from your dealer. To locate your nearest dealer, check the Dealer Locator at www.WoodsEquipment.com, or in the United States and Canada call
Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy,
NOTICE
■This equipment must be assembled and installed on the customer’s tractor by the Woods dealer. Dealer must thoroughly inspect equipment and complete each item on the
■Clean threaded holes in the tractor chassis thoroughly using a tap of the proper size. Paint, rust, or debris in the threads may not permit cap screws to be installed and tightened correctly.
TRACTOR PREPARATION
For installing this mounting kit, references to right, left, forward, and rearward directions are determined from the operator’s position in the tractor seat.
NOTE: Leave all loader mount hardware loose until mount is completely installed or otherwise instructed.
1.Shut off engine and set parking brake during installation.
2.Remove the tractor front weights and weight bracket if equipped.
3.Set tractor front wheel width to
4.Remove
As a valued customer, Woods appreciates your comments. Once loader mount and hydraulic hoses have been installed, please take a few minutes to complete the Loader Mount Evaluation sheet that was supplied with your loader mount. Your comments will help us continue to bring you quality products.
4 Mount Installation | MAN0064 (Rev. 7/20/2007) |
|
|