1023582 Hose Kit
Install Hoses
1.Attach straight end of hoses (1) to the IN, OUT and PBY ports of the loader control valve.
2.Locate the fill plug on the top of right rear axle and remove.
3.Install adapter (3) and adapter (11) into opening.
4.Attach hose from the PBY port on the loader control valve to elbow (12) in the PBY (N) port on the front of adapter plate (2).
5.Attach hose from the IN port on the loader control valve to adapter (21) in the PRESSURE (P) port on the side of adapter plate.
6.Attach hose from the OUT port on the loader control valve to adapter (11) in the RETURN port on the top of the rear axle.
1.1001422 Hose, 86" x 3/4 JICF x 3/4 JICF
2.1001421 Adapter plate
3.1001419 Adapter, 7/8
3.1001657 Adapter, 7/8
11. 316016 Adapter, 3/4 JICM x 7/8 ORBM | Figure 23. Hydraulic Fitting Installation |
|
12.316004 Elbow, 3/4 JICM x 3/4 ORBM 90°
21.61 Adapter, 3/4 JICM x 7/8 ORBM 90°
Install Hose Hanger
1.Install hose hanger bracket (14) under platform between brake pedals and chassis as shown in Figure 24.
2.Secure with hex head cap screw (18), flat washers (19), and lock nut (17).
3.Route hoses through hose hanger bracket and up behind right platform as shown in Figure 18.
4.Secure hoses in hose hanger with lock pin (13).
5.Secure hoses every 20 inches with plastic ties.
14.58033 Hose hanger bracket
13.58047 1/4 x
17.6778 5/16 NC Lock nut
18.6250 5/16 NC x
19.4378 5/16 Standard flat washer
Figure 24. Hose Hanger Installed
Figure 25. Hose Routing
MAN0064 (Rev. 7/20/2007) | Hydraulic Installation 17 |
|
|