Yard Machines OEM-190-032 warranty Model Series 600-649 All 800 series Cub Cadet 11C & 13C

Page 13

Lift Arm

Clevis Pin

Figure 14

Figure 15

Figure 16

Spring Attached to Idler Pulley

4.Align the holes in the rear of the lift arms with the holes in the rear of the undercarriage and insert the clevis pins removed in step 1. Fasten with the hairpin clips. See Figure 14.

5.Move the tractor’s deck lift lever into the top notch on the right fender allowing the lift arms and the rear of the undercarriage assembly to rise.

6.Insert the weldpins found on the top side of the rear portion of the undercarriage assembly up through the aligning holes found along the tractor’s frame rail. See Figure 15.

7.Fasten with the hairpin clips removed in step 1.

8.Repeat the previous two steps on the front portion of the undercarriage assembly.

9.Connect the extension spring to the tractor’s frame rail in the hole provided. See Figure 16.

NOTE: The other end of the spring is attached to the idler pulley. For an example of where this spring should attach, see Figure 14.

NOTE: Refer to the Routing the Upper Drive Belt section of this manual (Page 18) for proper upper drive belt installation instructions. Routing The Lower Drive Belt instructions can also be found in that section.

4

Assembly

Model Series

600-649 &

All 800 series

Cub Cadet 11C & 13C

WARNING

Before installing attachment, place tractor on a firm and level surface. Place the PTO in

the disengaged

(OFF) position, set the parking brake, shut engine off and remove key to prevent unintended starting.

13

Image 13

Contents OPERATOR’S Manual Customer Support Finding and Recording Model NumberDetermine The Model Your Rider FastAttach Snow Thrower Attachment To The OwnerRider Model Identiﬁcation Sample Model NumberYour Responsibility Restrict the use TrainingPreparationOperation Maintenance & StorageYour Responsibility Do not modify engineCarton Contents Contents of Carton Idler Pulley and Pin MountingManual PTO Tractors equipped with Or 42-inch deck onlyReversing Idler Assembly Hardware AssemblyMounting the Belt Keeper With a 46-inch deck onlyModel Series 600-649 All 800 series Cub Cadet 11C & 13C Undercarriage Assembly all tractors42, 46, 50, 54 inch Decks With Electric PTO Upper V-belt 754-0371AModel Series 600-649 Cub Cadet 11C 38 & 42-inch Undercarriage AssemblyUpper Drive Belt Reference Chart Mounting Undercarriage AssemblyDeck Size Lift Arm Clevis Pin Bracket Assembly Bracket Undercarriage AssemblyModel Series 700-799 PTO Cable Belt Keeper Pin Flange Lock Nut & Washer SlottedPin Mounting the Undercarriage AssemblyRemove Nut Hairpin Clip Attaching the Chute Directional Control Assembling ControlsAttaching Lift Handle Attaching the ReﬂectorsAttaching the Support Tubes Mounting Auger HousingInset a Inset B All electric PTO Belt RoutingVarious Models Decks 42, 46, 50Routing the Lower Drive Belt All Tractors Models Routing the Upper Drive Belt Older Style TractorsLeft Side Undercarriage Spindle Pulley Double-Idler Bracket Right SideChute Directional Control Engaging the Augers ImpellerQuickly Tire Chain Kit Number OperationMaking Adjustments AdjustmentsLift Adjustment Lower Chute Crank Support Bracket AdjustmentMaintenance MaintenanceBefore lubricating Repairing, or Lubrication Chute Directional ControlPage Snow Thrower 40 B Snow Thrower Attachment 12 8 Belt Guard Page Page MANUFACTURER’S Limited Warranty for