4 | WARNING: Before installing attach- |
|
| |
ment, place tractor on a firm and level |
|
| ||
surface. Place the PTO in the disen- |
|
| ||
gaged (OFF) position, set the parking |
|
| ||
brake, shut engine off and remove key |
|
| ||
to prevent unintended starting. |
|
| ||
Assembly | NOTE: References to LEFT and RIGHT indicate the left |
|
| |
Model Series | and right sides of the tractor when facing forward in the |
|
| |
operator’s position. Reference to the FRONT indicates |
|
| ||
|
| |||
the grille end; to the REAR the drawbar end. |
|
| ||
All 800 series. | IMPORTANT: You must first figure out which model of |
|
| |
| rider you are attaching this snow thrower to. Refer to |
|
| |
| Determine Your Model of Rider on page 3 of this manual |
|
| |
| to determine what model rider you are attempting to |
|
| |
| install this attachment to. Then proceed to the applicable |
|
| |
| instructions for your model of rider. |
|
| |
| Your tractor’s cutting deck, PTO belt and front deck |
|
| |
| stabilizer bracket must be removed prior to mounting |
|
| |
WARNING | the snow thrower attachment. Refer to your tractor’s |
|
| |
Operator’s Manual for detailed instructions. If your |
|
| ||
Before installing | tractor is equipped with any |
|
| |
attachment, place | front bumper kit), it must also be removed. |
|
| |
|
|
| ||
tractor on a firm | Mounting the |
|
| |
and level surface. |
|
| ||
Idler Pulley and Pin |
|
| ||
Place the PTO in |
|
| ||
the disengaged | (Manual PTO Tractors equipped with |
|
| |
(OFF) position, set | a 38- or |
|
| |
the parking brake, | Frame Mount Dual Idler Style 2004 & Prior | Weld Pin | Tractor Frame | |
shut engine off and | NOTE: If you engage your tractor’s cutting deck by | |||
|
| |||
remove key to prevent |
|
| ||
using your left hand to pivot a lever forward, your tractor |
|
| ||
unintended starting. | has a Manual PTO. If you engage your tractor’s cutting |
|
| |
| deck by pulling outward on a small knob located on the |
|
| |
| tractor’s dash, your tractor has an Electric PTO. |
|
| |
| The idler pulley and pin (packaged separately, refer to |
|
| |
| pages |
|
| |
| plate of all manual PTO tractors with a |
| PTO Engagement Plate | |
| 38- or |
| ||
|
|
| ||
| follows. Otherwise, proceed to Mounting the Under- |
| Figure 4 | |
| carriage Assembly. |
|
Locate the PTO engagement plate beneath your tractor. See Figure 4.
Note the location of the weld pin on the rear portion of the PTO engagement plate. This pin is where the deck brake cable attaches, when operating the tractor with the cutting deck mounted.
Remove the hair pin clip from the idler pulley and pin (packaged separately). Refer to pages
Position the idler pulley and pin onto the weld pin of the PTO engagement plate and secure with the hairpin clip just removed.
NOTE: This Idler pulley must be removed when remounting the tractor’s cutting deck.
8