8
Belt
Routing
Various Models
WARNING
Before installing attachment, place tractor on a firm and level surface. Place the PTO in the disen- gaged (OFF) position, set the parking brake, shut engine off and remove key to prevent unintended starting.
IMPORTANT:
Make certain that the flat side of the belt is facing outward. This allows the “V” side of the belt to ride snugly
in both pulleys.
Routing the Upper Drive Belt (Tractors Models with an Electric PTO)
Spindle Pulley |
| Engine Pulley |
| Idler Pulley | All electric PTO |
|
| |
|
| Decks 42, 46, 50, 54 |
PTO Idler Pulley
Figure 29
1.Attach and route the upper drive belt around the spindle pulley and idler pulley found on the undercarriage, the electric PTO clutch and the PTO idler pulley as illustrated in Figure 29. Make sure that the belt is routed to the INSIDE of the belt keeper on the undercarriage idler pulley and the remaining keeper pins found around the spindle pulley.
IMPORTANT: Make certain that the flat side of the belt is facing outward as it sits against both the electric PTO clutch and spindle pulley. This allows the “V” side of the belt to ride snugly in both pulleys.
Routing the Upper Drive Belt (Tractor Models 700 Series; and 600 Series 2005 & newer cable drive PTO)
Spindle Pulley | Engine Pulley |
All Manual PTO
Decks 38 & 42
PTO Idler Pulley
Figure 30
1.Attach and route the upper drive belt around the engine pulley and spindle pulley, routed to the INSIDE of the PTO idler pulley on the undercarriage. Make sure the belt is routed inside of the belt keeper pins found around the spindle pulley and engine pulley. See Figure 30.
IMPORTANT: Make certain that the flat side of the belt is facing outward. This allows the “V” side of the belt to ride snugly in both pulleys.
18