setup and adjustments
Setup
Uncrate machine.
ROPS Assembly Components
1 - Top loop
1 - Left side post
1 - Right side post
1 - Hardware bag
2 - Latch Pins w/lanyard
6 - Cap screws
6 - Centerlock nuts
2 - Knobs
(all hardware Grade 5).
1.Remove roll bar and parts bag from the box.
2.Install roll bar side posts.
a.Locate the LEFT and RIGHT side posts.
b.Slide the left side post into the left side receiver on the frame, do the same on the right side.
c.Using the cap screws, two per post, align the holes in the side post with the frame receiver. Install the centerlock nuts finger tight to the side post bolts.
3.Install roll bar top loop.
a.Align the holes of the top loop with the left and right side posts.
b.Slide the latch pins through the front hole on the left and right side to connect the top loop to the side posts and secure with the hairpin.
c.Insert cap screws through the rear hole on the left and right side. Install the centerlock nuts finger tight.
4.Torque all hardware to 80 ft./lbs. (110 N•m).
5.Install and tighten knobs against the side post.
6.If ROPS has been installed correctly, the unit should fold to the rear of the machine when not in use.
WARNING!
No settings or adjustments are to be made unless: Engine is stopped, key has been removed, park brake is on and battery cable removed from battery.
TOP LOOP
LATCH PIN
KNOB
½" CAPSCREW
½" CENTERLOCK NUT
RIGHT SIDE
POST
LEFT SIDE
POST
½" CENTERLOCK NUTS
½" CAPSCREWS