CONTROLS
Tracking
If the mower is not tracking straight, check the air pressure in both rear tires. Recommended air pressure is 15 psi (1 bar). Tracking must be checked on a flat and level concrete or blacktop surface.
The tracking knob is located in front of the left control lever. Rotating this knob allows fine tuning adjustments so that the machine tracks straight with the drive levers in the full forward position.
Rotate the knob clockwise (as viewed from the operating position) to increase the speed or counterclockwise to decrease the speed on the left control lever. Example: If control levers are full forward and the unit turns to the right, turn the tracking knob counterclockwise to decrease the speed on the left control lever.
If unit still does not track straight, contact a Yazoo/ Kees dealer for adjustment.
Tracking Knob
Bypass Linkages
When pushing or pulling the mower, be sure to open the release valves on the both hydraulic pumps.
Always turn off engine before engaging or disengaging the hydro release. Never attempt to adjust the bypass linkages with the engine running.
The hydro release valves are located below the seat, on the front side of the hydro pumps.
1.Raise the deck into highest cutting position.
2.Lift the seat frame assembly to access the release valves.
3.Use a 5/8" wrench to rotate bolt counter- clockwise two full turns to disengage pump.
4.Repeat the procedure for the opposite pump.
5.To engage, rotate each pump bolt clockwise until the bolt is snug. Do not overtighten the release valve or damage to the hydro pump could occur.
Bypass release valve