setup and adjustments
Tires
Mount rear drive wheels using the lug nuts installed on the hubs.
Check the tire pressure in all four tires. All tires should be 15 psi.
Control Arms
Remove top bolt in control arm and loosen bottom bolt, rotate the control levers to the upright position. Align the levers so they are even in the neutral position. Reinstall hardware and tighten.
Motion Control Lever
Seat Install
1.Remove seat assembly from the crate.
2.Remove the four nuts from the bottom of the seat. Retain for use later.
3.Align the seat bottom with the holes in the seat frame. Place seat on top of the seat frame and secure with the four nuts or knobs removed in Step 2.
4.Connect the wire harness from the seat to the frame harness.
Engine Oil
Check engine oil with dip stick. Add if needed per the engine manufactures specifications. See engine manual for oil type and filling specifications.
Operating
Range
Control Arm
“F” Full
Mark