5.Adjust the Gain Down [4] until the bar graphs open.
−−The bar graph will close, the audio will increase, and the signal strength will be maximum when the receiver detects a marker of the specified utility.
−−When one of the two markers is detected, press the “XXX Only” [SK] for the detected utility marker.
−−The unit will switch to Single Marker Locate in order to pinpoint the marker.
6.Press Markr 2 [SK Toggle] to return to Dual Marker Locate.
Marker Depth Estimate
ID Marker Depth
1.Lower the tip of the receiver to the ground over the targeted marker.
2.Press Depth [SK].
−−The receiver will examine the marker (Calculating, please wait...)
−−If the marker is a 3M™ Dynatel™ iD Marker, the receiver will display the depth of the marker, and its identification number.
3.To save the depth reading, press Mem Select [SK].
−−Five depth readings can be saved with the time, date, and its identification number.
−−Save [SK] will place each entry in sequential order in memory (M1 - M5) until five readings have been stored. The unit will overwrite saved entries in excess of five, beginning with M1.
4.Press Clear All [SK] to delete all stored depth information.
5.Press Mem Select [SK] to select the memory location to store the depth readings. When the preferred location appears on the screen, press Save [SK]. The screen and memory location will populate with the current information.
6.Each memory location can be reviewed by pressing Mem Select [SK].
7.Press Locate [5] to return to Marker Locate Mode.
| 31 |