Writing iD Markers
The Write Mode enables the user to write or program information into 3M™ EMS iD Markers. It is also possible to edit the information to be programmed.
Menu [6] + Write Mode [SK]
1.Select a template from the list on the screen to be programmed into the marker by pressing the up/down arrows [SK] to highlight the preferred template. ‘Last Written’ is the most recent data that was programmed to a marker by the receiver.
2.Press View/Edit [SK].
−−The screen will display the information from the selected template. The arrow on the right side of the screen indicates there is more information than can be displayed on the screen (scroll down by pressing the down arrow [SK]).
3.Enter user information that will be written to this marker. (See Modifying Marker Data to be Programmed section.)
4.Verify all information is correct.
5.Press Write Marker [SK].
6.Select type of marker to be written Marker [SK Toggle].
7.Hold the receiver directly over the top of the marker. The receiver should be within 12 inches (30 cm) of the marker.
8.Press Start Write [SK].
−−The receiver will ask if the user wants to permanently lock the marker data.
36 |
|