3M 2250ME-iD, 2273ME-iD manual Cable Identification, Transmitter Setup

Cross:

Figure #2 Red clip to the crossed conductor of one pair; Black clip to the crossed conductor of the other pair.

Ground:

Figure #3 Red clip to the faulted conductor;

Black clip to ground.

Split:

Figure #4 Red clip to Tip of Pair 1; Black clip to Ring of Pair 1.

Verify Split:

Figure #5 Red clip to good conductor of Pair 1;

Black clip to split conductor of Pair 2

Cable Identification

Transmitter Setup

1.Connect the 3M™ Dynatel™ Dyna-Coupler to the Transmitter output jack [T-6] using the coupler cable.

Note: Cable Identification requires two Dyna-Couplers: one at the Transmitter and one at the Receiver.

2.Clamp the Dyna-Coupler around the cable or both the tip and ring of a pair. Make sure the jaws fully close.

3.Press and hold [T-1] to perform a battery check.

4.Press OHMS/FAULT/TONE [T-2] three times to set the transmitter to Tone mode.

−−The indicator flag will light in the display [T-4] under the tone icon.

5.Press OUTPUT [T-5] for high output level.

−−The indicator flag will light in the display [T-4] above the output icon.

−−The display [T-4] will alternately flash between 577 and 133K.

78-8130-6151-8-E 45