Northern Industrial Tools M1107C owner manual

Page 1

M1107C

ITEM NUMBER:

1107

SERIAL NUMBER: _____________________

Owner’s Manual

Instructions for Assembly, Testing, Operation, Servicing, &

Storage

20 Ton Log Splitter: Outdoor hydraulic powered machine that splits wood logs.

WARNING

READ and UNDERSTAND this manual completely before using log splitter.

All operators of this equipment must read and completely understand all safety information, operating instructions, maintenance and storage instructions. Failure to properly operate and maintain the log splitter could result in serious injury to the operator and bystanders from moving parts that can crush or cut, flying objects, burns, fire or explosion, escaping high pressure hydraulic fluid, or carbon monoxide poisoning in particular, be aware of the following hazards.

Crush and Cut Hazards

Moving parts can crush and cut hands and fingers. Keep hands clear of endplate, wedge, and logs while splitting. High Pressure Hydraulic Fluid Hazards

High fluid pressures and temperatures are developed in hydraulic Log splitters. Hydraulic fluid escaping through even a pin-size hole opening can puncture skin and cause severe blood poisoning. Inspect hydraulic system regularly for possible leaks. Never check for leaks with your hand while the system is pressurized. Seek medical attention immediately if injured by escaping fluid.

Fire Hazards

If your log splitter is intended for use near and ignitable forest, brush, or grassy covered land, the engine exhaust should be equipped with a spark arrestor. See the “Specifications” section of this manual to determine if your splitter is equipped already has a spark arrestor. If not equipped, call Northstar Customer Service for ordering information.

Keep a fire extinguisher with you, that is rated for ordinary combustibles and flammable liquids.

STOP!

ADD OIL TO ENGINE BEFORE USING: Engine is shipped without oil. DO NOT start log splitter without first adding oil.

VERIFY HYDRAULIC OIL LEVEL: Hydraulic reservoir is shipped with oil. Verify oil level is 1” from top before using.

INSPECT COMPONENTS: Closely inspect to make sure no components are missing or damaged.

See “Initial Unpacking and Setup” section for instructions and whom to contact to report missing or damaged parts.

Any Questions, Comments, Problems or Parts Orders

Call NorthStar Customer Service 1-800-270-0810

1

Page 1 Page 2
Image 1
Page 1 Page 2
Contents M1107C Hazard Signal Word Definitions Table of Contents This equipment to others About Your Log SplitterAbout Your Log Splitter Safety Label Locations Safety Label Locations Description Machine Component IdentificationRef Description Initial Unpacking & Set-Up Rail Beam Replace fill capMoving the log splitter Moving and Towing to Job SitePlace Fuel valve offTowing Attach safety chainsRead Attach to hitch Attach log splitter to vehicle hitch BallMoving and Towing to Job Site Step One Inspect and maintain log splitter before each use Before Each Use-Inspection / MaintenanceFuel tank / lines Check fuel tank and fuel lines for leaks Hydraulic system Check the hydraulic system carefullyTires Step Two Fueling Before Each Use FuelingStep Three Work site selection and log splitter set-up Before Each Use Work Site Selection & Set-UpSelect location Combustibles orLock both legs Splitting Operation General safety informationHorizontal lock VerticalStart engine Start the engine Vertical SplittingCorrect Log Orientation Stop wedge Extend wedgeInstructions below to remove the log Stuck LOGReturn to horizontal position Storage Periodic Maintenance Any Questions, Comments, Problems or Parts Orders TroubleshootingProblem Cause SolutionSpecifications Parts Breakdown-Exploded View 1107 REV C PART# Description QTY Summary of Important Safety Information for Operation Safety Before Use Read/instruct Safety During TowingSafety During Inspection/Maintenance Personal protective equipmentSafety in Work Site Selection Safety During FuelingSafety in Loading, Operating, and Unloading Safety During Use General Safety During Use Loading/Unloading Safety After useSummary of Important Safety Information for Operation
Top Page Image Contents