Northern Industrial Tools M1107C owner manual Splitting Operation, General safety information

Page 18

Splitting Operation

WARNING

Before starting this log splitter, review the following instructions and safety information for safe operation of the log splitter.

Failure to follow these rules may result in serious injury to the operator or bystanders from moving parts that crush, cut, or entangle, from flying objects, burns, fire, falling or tripping, or from carbon monoxide poisoning.

General safety information:

Read manual. Do not allow anyone to operate the log splitter who has not read the Owner’s Manual or has not been instructed on the safe use of the splitter. The log splitter owner should instruct all operators in safe log splitter operation.

Age restrictions. Never allow anyone under 16 years old to operate the log splitter. Children 16 years and older must be trained and supervised by a trained adult.

Intended use. Log splitters should only be used for splitting wood logs, lengthwise with the grain. Do not use for other purposes as unforeseen hazards may result.

Modifications. Never modify or alter the log splitter in any way. Modifications can create serious safety hazards and will void the warranty:

Attachments. Never add attachments to the splitter, except for authorized accessories supplied by the manufacturer with instructions for safe installation and use.

Engine speed. The maximum engine speed is preset at a safe limit. Never attempt to modify the engine speed setting to run at a higher speed.

Fuel/exhaust system. NEVER modify or add to the exhaust system, fuel tanks, or fuel lines. Fire can result.

Remote control. NEVER attach a rope, cable, or other remote device to the splitting control.

Splitting wedge. NEVER attempt to change the height or speed of the splitting wedge.

Pressure setting. NEVER increase the pressure setting of the pump or control valve.

Safety equipment / controls. Always operate the log splitter with all safety equipment in place and in good working order, and all controls properly adjusted for safe operation.

Know how to stop. Be thoroughly familiar with all controls and with the proper use of the equipment. Know how to stop the log splitter and relieve system pressures quickly if needed.

Operating speed. Always operate the log splitter at the manufacturer’s recommended speed. The maximum speed of the engine pump and wedge are preset within safe limits.

Daylight only. Only use the log splitter in daylight so you can see what you are doing.

Smoking / sparks. Never smoke while operating the log splitter, and never operate near sources of sparks or flames.

Under the influence. Never operate, or let anyone else operate, the log splitter while under the influence of alcohol, drugs, or medication.

Unattended. Never leave the machine unattended while the engine is running.

Refueling. Never refuel the engine until it has cooled at least two minutes.

Adjusting / repairing. Always make sure the engine is off before cleaning, repairing or adjusting the splitter, except as recommended by the manufacturer. In addition, disconnect the spark plug and move all control handles back and forth to relieve system pressure before changing or adjusting hydraulic system components such as hoses, tubing, fittings or other components.

Replace labels. Always make sure safety labels are in place and in good condition. If a safety label is missing or not legible, order new labels because unsafe operation can result. Call 1-800-270-0810 to order new safety labels.

18

Image 18
Contents M1107C Hazard Signal Word Definitions Table of Contents About Your Log Splitter This equipment to othersAbout Your Log Splitter Safety Label Locations Safety Label Locations Machine Component Identification DescriptionRef Description Initial Unpacking & Set-Up Replace fill cap Rail BeamPlace Moving and Towing to Job SiteMoving the log splitter Fuel valve offRead Attach safety chainsTowing Attach to hitch Attach log splitter to vehicle hitch BallMoving and Towing to Job Site Fuel tank / lines Check fuel tank and fuel lines for leaks Before Each Use-Inspection / MaintenanceStep One Inspect and maintain log splitter before each use Hydraulic system Check the hydraulic system carefullyTires Before Each Use Fueling Step Two FuelingSelect location Before Each Use Work Site Selection & Set-UpStep Three Work site selection and log splitter set-up Combustibles orLock both legs General safety information Splitting OperationVertical Horizontal lockVertical Splitting Start engine Start the engineCorrect Log Orientation Extend wedge Stop wedgeStuck LOG Instructions below to remove the logReturn to horizontal position Storage Periodic Maintenance Problem TroubleshootingAny Questions, Comments, Problems or Parts Orders Cause SolutionSpecifications Parts Breakdown-Exploded View 1107 REV C PART# Description QTY Summary of Important Safety Information for Operation Safety During Inspection/Maintenance Safety During TowingSafety Before Use Read/instruct Personal protective equipmentSafety During Fueling Safety in Work Site SelectionSafety During Use General Safety During Use Safety in Loading, Operating, and UnloadingSafety After use  Loading/UnloadingSummary of Important Safety Information for Operation