MTD 7304 manual Battery Removal, Battery Maintenance, Battery Storage

Page 31

•Because battery acid is corrosive, do not pour it into any sink or drain. Before discarding an empty electrolyte container, rinse it thoroughly with a neutralizing solution.

•NEVER connect (or disconnect) battery charger clips to the battery while the charger is turned on, as it can cause sparks.

•Keep all sources of ignition (cigarettes, matches, lighters) away from the battery. The hydrogen gas generated during charging can be combustible.

•As a further precaution, only charge the battery in a well ventilated area.

•Always shield eyes and protect skin and clothing when working near batteries.

WARNING: Batteries contain sulfuric acid and may emit explosive gases. Use extreme caution when handling batteries. Keep batteries out of the reach of children.

BATTERY REMOVAL

WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. Wash hands after handling.

The battery is located at the front of the tractor beneath the hood, just forward of the radiator.

To remove the battery:

•Open the tractor hood as described in the previous sub-section.

•Remove the two wing nuts and the battery holddown strap from the battery holddown rods. See Figure 36.

•Spread the locking clips on the sides of the terminal covers and lift the tops of the covers to expose the battery connections. See Figure 36

•Loosen the cable clamp of the negative battery lead, then lift the negative cable and its termi- nal cover off the negative battery post. Move the cable away from the negative battery post.

•Repeat the above procedure to remove the cable and cover from the positive battery post.

•Carefully lift the battery out of the tractor.

Install the battery by repeating the above steps in the reverse order.

WARNING: Always connect the posi- tive lead to the battery before con- necting the negative lead.

HOLDDOWN STRAP

 

 

 

CABLE

 

WING NUT

 

 

 

 

 

CLAMP

 

 

 

 

 

 

 

 

 

 

 

BATTERY

 

TERMINAL

 

HOLDDOWN

 

 

COVER

ROD

 

 

 

 

Figure 36

BATTERY MAINTENANCE

The battery is filled with battery acid and then sealed at the factory. However, even a “maintenance free” battery requires some maintenance to ensure its proper life cycle.

•Spray the terminals and exposed wire with a battery terminal sealer, or coat the terminals with a thin coat of grease or petroleum jelly, to protect against corrosion.

•The battery should be kept clean. Any deposits of acid should be neutralized with baking soda and water. Be careful not to get this solution in the cells.

•Avoid tipping. Even a sealed battery will leak electrolyte when tipped.

BATTERY STORAGE

•When storing the tractor for extended periods, disconnect the battery cables. Removing the battery from the unit is recommended.

•All batteries discharge during storage. Keep the exterior of the battery clean, especially the top. A dirty battery will discharge more rapidly.

•The battery must be stored with a full charge. As the battery discharges, the electrolyte is weakened and will freeze at a higher temperature.

•Recharge the battery before returning to service; or every two months, whichever comes first.

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Operator’s Manual Important Read Safety Rules and Instructions CarefullyCalling Service Information Table of ContentsTo the Owner Tractor Model Plate Recording Model and Serial Number InformationRops Information Plate General Operation Important Safe Operation PracticesDo not Slope OperationChildren Operating the PTOService Safety Frame RopsFAN Warning Label Located on Each Side of Radiator Safety LabelsStarting AID Located Under Hood PTO Warning Label Located on Rear PTO Shield Battery Warning Label Located Under HoodRoll Over Warning Label Located on RIGHT/REAR Fender Floorboard and Dash Panel Mounted Controls Controls and FeaturesSteering Wheel PTO SwitchIgnition Switch Seat Adjustment LeverParking Brake Lever Hazard Light SwitchHeadlight Switch Differential Lock PedalEngine Coolant Temperature Light Parking Brake Indicator LightPTO Indicator Light Tachometer Battery Indicator LightPTO Selection Lever Fender Mounted Conrtols and FeaturesPTO Reverse Override Switch Fuel Fill CapAmber Hazard Lights Transmission Hi/Lo Range Shift LeverCup Holder Hand HoldsRollover Protective Structure Rops OperationFolding the Rops NEW Tractor BREAK-IN Procedures Safety Interlock SystemFueling the Tractor Stopping the Engine Using Jumper Cables to Start the EngineStarting the Engine Cold Weather StartingStopping the Tractor Using the FORWARD/REVERSE PedalDriving the Tractor Driving on SlopesUsing the Differential Lock Pedal Using the HI/LO Range Shift LeverLOW Using the PTO Selection Lever Using the Hydraulic Lift LeverEngaging the PTO Lighting Using the PTO Reverse Override SwitchUsing the TOP Link Retainer Hook Hazard LightsUsing the Auxiliary Hydraulic Control Handle Using the Three Point HitchUsing the Hitch Plate Using the Auxiliary Hydraulic Valve if EquippedOn Demand Four Wheel Drive Tractor WeightingThree Point Hitch Adjustments AdjustmentsAdjusting the Seat Adjusting the Seat BeltCheck the TOE-IN AS Follows Adjusting Front Wheel TOE-INAdjusting Hydraulic Lift Feedback ROD Adjusting the BrakesLubrication Table MaintenanceGeneral Information Lubrication and Maintenance Chart Illustration Service Intervals Operation to Lubrication and Maintenance ChartGeneral Battery Information Accessing the Engine CompartmentBattery Maintenance Battery RemovalBattery Storage Hazard Bulb Replacement Head Light Bulb ReplacementTail Light Bulb Replacement Instrument Panel Fuses Instrument Panel Bulb ReplacementAccessing the Fuse Center Servicing Electrical SystemHazard Light Flasher Relay Main FuseChecking TRANSMISSION/HYDRAULIC System OIL Level Changing TRANSMISSION/HYDRAULIC System OIL Initial Break-In Period Filter Change Check Final Reduction Gear Case Oil Check Front Axle OilChanging Front Axle and Final Reduction Gear Case OIL Wheel Bolt Torque Maintenance of the Rollover Protective Structure RopsLubrication of Main Drive Shaft Lubrication of FWD Drive ShaftTractor Storage Tire MaintenanceRemoving the Tractor from Storage Daihatsu Emission Control Defects Warranty Coverage Engine Information and MaintenanceFuel Metering System Cleaning the Radiator Screen and Radiator Engine Maintenance Cleaning the EngineChecking Engine OIL Level Changing the Engine OIL and Filter Adding Engine OILChecking Engine Coolant Level Inspection of Cooling System Hoses Changing the AIR CleanerChanging the Engine Coolant Draining The Fuel Filter Cup Servicing the Fuel FilterChanging The Fuel Filter Specifications Brakes Power Take-OffGeneral Dimensions Hydraulic Lift SystemDescription Model Number Optional Equipment and AccessoriesCLEVELAND, Ohio CUB Cadet LLC Post Office BOX

7304 specifications

The MTD 7304 is a powerful and efficient lawn mower that is designed for both residential and commercial use. Known for its reliability and performance, the MTD 7304 has become a popular choice among homeowners and landscape professionals alike. This mower is equipped with a range of features and technologies that enhance its functionality, making yard maintenance an easier task.

One of the standout features of the MTD 7304 is its robust engine. Powered by a durable, high-performance engine, this mower ensures consistent power delivery, making it suitable for tackling a variety of grass types and terrains. The engine is engineered for fuel efficiency, which not only helps in reducing operating costs but also minimizes environmental impact.

The cutting deck of the MTD 7304 is another highlight, typically measuring around 30 inches. This size strikes a perfect balance between maneuverability and cutting capacity, allowing users to navigate through narrow spaces while still covering significant areas in a single pass. The mower also incorporates adjustable cutting heights, providing flexibility for different grass lengths and conditions.

Equipped with advanced technology, the MTD 7304 includes an easy-to-use electric start feature. This eliminates the hassle of pull-starting, making the mower accessible to users of all ages. The mower is also designed with a user-friendly control panel, featuring intuitive controls that allow for effortless operation and adjustments while mowing.

Durability is a key characteristic of the MTD 7304, with high-quality construction materials that can withstand the rigors of regular use. The sturdy frame and components contribute to the mower's long lifespan, ensuring that it remains a reliable choice for years to come. Additionally, the mower often features a robust warranty that reflects the manufacturer's confidence in its durability.

Another notable aspect of the MTD 7304 is its ergonomic design. Comfortable handles and adjustable height options provide ease of use, reducing fatigue during extended mowing sessions. The compact design also aids in storage, allowing users to store the mower in smaller spaces without any hassle.

In summary, the MTD 7304 is a versatile mower that combines power, efficiency, and durability. With its advanced features, user-friendly technologies, and ergonomic design, it stands out as a top choice for those seeking effective lawn care solutions. Whether for a residential lawn or commercial landscaping, the MTD 7304 delivers exceptional performance, making it a valuable addition to any outdoor maintenance toolkit.
Top Page Image Contents