MTD 7304 manual Servicing the Fuel Filter, Draining The Fuel Filter Cup

Page 47

•Pull the air cleaner element from the housing. See Figure 59.

AIR

 

 

 

AIR

CLEANER

 

 

 

CLEANER

 

 

ELEMENT

 

 

 

HOUSING

Figure 59

•Lightly blow or brush loose debris from the air cleaner element. Clean any debris from the housing.

•Inspect the paper pleats of the cleaner element for damage and dirt. Inspect the sealing surface on the inner end of the element for deterioration or damage. Replace a damaged or dirty air cleaner element.

•Push the new air cleaner element fully into the housing.

•Position the cover on the housing. Hook the two clamps onto the rim of the housing and lock the clamps. Refer to Figure 58.

IMPORTANT: A clean and properly installed air cleaner element significantly contributes to prolonging engine life.

SERVICING THE FUEL FILTER

WARNING: Do not service the fuel filter when tractor is hot or near any source of ignition. Allow the tractor to cool.

The tractor is equipped with an in-line fuel filter located on the right side of the engine. Regularly check the cup at the bottom of the fuel filter for condensate water that has separated from the diesel fuel (Refer to Figure 60). Drain the filter cup as needed, or after every 100 hours of operation. Replace the fuel filter after every 600 hours of operation.

Diesel fuel is a toxic substance. Dispose of in an environmentally safe manner. Contact your area EPA office for proper disposal methods and recycling center locations.

Draining The Fuel Filter Cup

•Stop the engine.

•Place a suitable container beneath the filter cup. See Figure 60.

AIR BLEED KNOB

CUP DRAIN

 

 

 

 

 

FUEL FILTER

 

 

 

 

 

 

 

 

FILTER CUP

 

 

 

 

 

 

 

 

Figure 60

•Turn the cup drain counterclockwise to open. Allow the water at the bottom of the cup to drain until only diesel fuel remains in the cup. See Figure 61.

•Turn the cup drain clockwise to close. See Figure 61.

Turn to

Turn to

FILTER

Open

Close

CUP

CUP DRAIN

Figure 61

•Slowly turn the air bleed knob counterclock- wise until fuel refills the filter cup and begins to seeps out around the bleed knob. Turn the air bleed knob clockwise to close. Refer to Figure 60.

47

Page 46 Page 48
Image 47
Page 46 Page 48
Contents Operator’s Manual Important Read Safety Rules and Instructions CarefullyTo the Owner Table of ContentsCalling Service Information Rops Information Plate Recording Model and Serial Number InformationTractor Model Plate General Operation Important Safe Operation PracticesDo not Slope OperationChildren Operating the PTOService Safety Frame RopsStarting AID Located Under Hood Safety LabelsFAN Warning Label Located on Each Side of Radiator Roll Over Warning Label Located on RIGHT/REAR Fender Battery Warning Label Located Under HoodPTO Warning Label Located on Rear PTO Shield Floorboard and Dash Panel Mounted Controls Controls and FeaturesSteering Wheel PTO SwitchIgnition Switch Seat Adjustment LeverParking Brake Lever Hazard Light SwitchHeadlight Switch Differential Lock PedalEngine Coolant Temperature Light Parking Brake Indicator LightPTO Indicator Light Tachometer Battery Indicator LightPTO Selection Lever Fender Mounted Conrtols and FeaturesPTO Reverse Override Switch Fuel Fill CapAmber Hazard Lights Transmission Hi/Lo Range Shift LeverCup Holder Hand HoldsFolding the Rops OperationRollover Protective Structure Rops Fueling the Tractor Safety Interlock SystemNEW Tractor BREAK-IN Procedures Stopping the Engine Using Jumper Cables to Start the EngineStarting the Engine Cold Weather StartingStopping the Tractor Using the FORWARD/REVERSE PedalDriving the Tractor Driving on SlopesLOW Using the HI/LO Range Shift LeverUsing the Differential Lock Pedal Engaging the PTO Using the Hydraulic Lift LeverUsing the PTO Selection Lever Lighting Using the PTO Reverse Override SwitchUsing the TOP Link Retainer Hook Hazard LightsUsing the Auxiliary Hydraulic Control Handle Using the Three Point HitchUsing the Hitch Plate Using the Auxiliary Hydraulic Valve if EquippedOn Demand Four Wheel Drive Tractor WeightingThree Point Hitch Adjustments AdjustmentsAdjusting the Seat Adjusting the Seat BeltCheck the TOE-IN AS Follows Adjusting Front Wheel TOE-INAdjusting Hydraulic Lift Feedback ROD Adjusting the BrakesGeneral Information MaintenanceLubrication Table Lubrication and Maintenance Chart Illustration Service Intervals Operation to Lubrication and Maintenance ChartGeneral Battery Information Accessing the Engine CompartmentBattery Storage Battery RemovalBattery Maintenance Tail Light Bulb Replacement Head Light Bulb ReplacementHazard Bulb Replacement Instrument Panel Fuses Instrument Panel Bulb ReplacementAccessing the Fuse Center Servicing Electrical SystemChecking TRANSMISSION/HYDRAULIC System OIL Level Main FuseHazard Light Flasher Relay Changing TRANSMISSION/HYDRAULIC System OIL Initial Break-In Period Filter Change Changing Front Axle and Final Reduction Gear Case OIL Check Front Axle OilCheck Final Reduction Gear Case Oil Wheel Bolt Torque Maintenance of the Rollover Protective Structure RopsLubrication of Main Drive Shaft Lubrication of FWD Drive ShaftTractor Storage Tire MaintenanceRemoving the Tractor from Storage Daihatsu Emission Control Defects Warranty Coverage Engine Information and MaintenanceFuel Metering System Checking Engine OIL Level Engine Maintenance Cleaning the EngineCleaning the Radiator Screen and Radiator Changing the Engine OIL and Filter Adding Engine OILChecking Engine Coolant Level Changing the Engine Coolant Changing the AIR CleanerInspection of Cooling System Hoses Draining The Fuel Filter Cup Servicing the Fuel FilterChanging The Fuel Filter Specifications Brakes Power Take-OffGeneral Dimensions Hydraulic Lift SystemDescription Model Number Optional Equipment and AccessoriesCLEVELAND, Ohio CUB Cadet LLC Post Office BOX

7304 specifications

The MTD 7304 is a powerful and efficient lawn mower that is designed for both residential and commercial use. Known for its reliability and performance, the MTD 7304 has become a popular choice among homeowners and landscape professionals alike. This mower is equipped with a range of features and technologies that enhance its functionality, making yard maintenance an easier task.

One of the standout features of the MTD 7304 is its robust engine. Powered by a durable, high-performance engine, this mower ensures consistent power delivery, making it suitable for tackling a variety of grass types and terrains. The engine is engineered for fuel efficiency, which not only helps in reducing operating costs but also minimizes environmental impact.

The cutting deck of the MTD 7304 is another highlight, typically measuring around 30 inches. This size strikes a perfect balance between maneuverability and cutting capacity, allowing users to navigate through narrow spaces while still covering significant areas in a single pass. The mower also incorporates adjustable cutting heights, providing flexibility for different grass lengths and conditions.

Equipped with advanced technology, the MTD 7304 includes an easy-to-use electric start feature. This eliminates the hassle of pull-starting, making the mower accessible to users of all ages. The mower is also designed with a user-friendly control panel, featuring intuitive controls that allow for effortless operation and adjustments while mowing.

Durability is a key characteristic of the MTD 7304, with high-quality construction materials that can withstand the rigors of regular use. The sturdy frame and components contribute to the mower's long lifespan, ensuring that it remains a reliable choice for years to come. Additionally, the mower often features a robust warranty that reflects the manufacturer's confidence in its durability.

Another notable aspect of the MTD 7304 is its ergonomic design. Comfortable handles and adjustable height options provide ease of use, reducing fatigue during extended mowing sessions. The compact design also aids in storage, allowing users to store the mower in smaller spaces without any hassle.

In summary, the MTD 7304 is a versatile mower that combines power, efficiency, and durability. With its advanced features, user-friendly technologies, and ergonomic design, it stands out as a top choice for those seeking effective lawn care solutions. Whether for a residential lawn or commercial landscaping, the MTD 7304 delivers exceptional performance, making it a valuable addition to any outdoor maintenance toolkit.
Top Page Image Contents