Multiquip SP706026 RAISE-LOWER Controls, Raise Lower Controls, Setting the Depth Indicator

RAISE-LOWER CONTROLS

RAISE - LOWER CONTROLS

The SP7060 saw uses a 12-volt hydraulic pump and cylinder to raise and lower the saw. The raise-lower function is controlled by the operator through a 3-position toggle switch on the raise-lower control handle located on the operator’s control panel.

Figure 27. Raise-Lower Control Toggle Switch

1.To lower the blade, push the toggle switch located on the end of the control handle FORWARD (Figure 27).

2. To raise the blade, pull the toggle switch located on the end of the control handle BACKWARD.

Setting the Depth Indicator

1. Lower the blade until it just touches the cutting surface.

2. Set the depth indicator dial to zero.The depth indicator now accurately indicates how deep the blade is cutting (Figure 28).

Figure 28. Depth Indicator

Depth Control System

The SP7060 saw uses an electronically controlled depth stop to position and lock the blade at the desired cut depth.

To control the depth of cut with the saw running and blade mounted:

1.Raise the saw above the desired cutting depth.

2.Turn the depth control knob counterclockwise until the saw cannot be lowered by pushing the raise/lower switch forward (Figure 29).

1

Raises

Lowers

2

1

6

4

5

31. Depth Control Knob

2.Raise/Lower Toggle Switch

3.Adjuster Bracket

4.Adjuster Cable/Spring assy.

5.Adjuster Nut

6.Depth Control Housing

Figure 29. Setting Depth Gauge and Depth Stop

3.Hold the raise/lower toggle switch in the lowering position by pushing it forward and rotate the depth control knob clockwise until the desired cutting depth is achieved. The saw will repeat to the same depth

until readjusted.

PAGE34 — SP7060 PAVEMENT SAW • OPERATION MANUAL — REV. #0 (02/13/09)