Multiquip gb43sc manual Globug 4-SPOT Setup, GloBug Setup, Lamp Assembly

CAUTION - Read Manual

Please read this entire manual carefully before attempting to operate the GloBug. Failure to read this manual could cause damage to the GloBug and serious injury to the operator.

GloBug Setup

1.Using the T-handle (Figure 7) place the GloBug on a firm level surface so that it will not slide or turn over.

GLOBUG 4-SPOT — SETUP

3.Lift up on each outrigger (2) from its stow position, rotate backwards and place it in the deployed position, as shown in Figure 9.The outriggers will automatically lock in place once they touch the ground,

STOW

POSITION

DEPLOYEDOUTRIGGERS

Figure 9. Outriggers (Deployed Position)

Figure 7. T-Handle (Directional Control)

2.To apply the parking brake (Figure 8), step on the brake pedal and pull back on the T-handle. This will lock the rear wheels. For additional safety use chock blocks to

prevent rolling.

STEP DOWN

ON BRAKE PEDAL

Lamp Assembly

1.Screw the lamp into the socket (use 400 watt metal- halide type lamp). Always allow a sufficient amount of time for the lamp to cool down before changing. See Figure 10.

LAMP

SOCKET

Figure 10. Installing the Lamp

PARKING

BRAKE SET

Figure 8. Parking Brake (Set Position)

PAGE 18 — GLOBUG 4-SPOT — OPERATION AND PARTS MANUAL — REV. #3 (12/15/08)