GLOBUG 4-SPOT — RULES FOR SAFE OPERATION
■ALWAYS make sure that the GloBug is secure on firm level ground so that it cannot slide or shift around, endangering workers. Also keep the immediate area free of bystanders.
■ALWAYS keep area behind GloBug clear of people while raising and lowering mast.
■To prevent the GloBug from overturning, NEVER use in winds that exceed 22 mph(10m/s).
■To prevent the GloBug from rolling, ALWAYS place the GloBug on a firm flat surface. Surface slant should not exceed 5 degrees.
■To prevent the GloBug from rolling, ALWAYS apply the parking brake. For additional safety place chock blocks behind the wheels.
■The GloBug must use a generator that is at least 220 lbs. (100 kg) minimum.This will prevent the GloBug from tipping over.
■The GloBug should only be used in temperatures between
■NEVER use the GloBug in rain, snow or areas of high humidity that could generate electrical storms.
■Set the GloBug's tire air pressure to 35.5 psi (245kPa). Check daily. Low tire pressure could adversely affect the parking brake.
MAST SAFETY |
|
■ When raising or lowering the mast, |
|
keep hands and fingers clear of | PINCH |
the various mast sections, this will | POINT |
prevent hands and fingers from |
|
getting pinched. |
|
■When raising the mast and to prevent tipping, ALWAYS deploy outriggers.
■CHECK the mast and winch cables for wear.If any problem occurs when lower or raising the mast STOP immediately! Contact a trained MQ technician for assistance.
■NEVER pivot or retract mast while unit is operating.
■NEVER use the lighting system mast as a crane. DO NOT lift anything with the mast.
■NEVER attach anything to the lighting system mast.
■ALWAYS lower the tower when not in use, or if high winds or electrical storms are expected in the area.
LIFTING/TRANSPORTINGTHE GLOBUG
■ALWAYS use the lifting hanger, when lifting of the GloBug is required.
LIFTING
HOOK
LIFTING
HANGER
LIFTING
SCHACKLE
GENERATOR
LIFTING BALE
■Use a crane, forklift or suitable lifting device of adequate lifting capability when the lifting of the GloBug is required.
■Make sure the mast is completely lowered before lifting the GloBug.
■When the GloBug is lifted from its correct lifting point, it should lift straight up (not tilted). DO NOT attempt to lift the GloBug if its position is tilted while lifting.
INCORRECT | CORRECT |
|