Multiquip GB114BC manual Globug Lighting System PRE-SETUP, Positioning the Balloon

GLOBUG LIGHTING SYSTEM — PRE-SETUP

5.To position the balloon, simply loosen the adjustment lever by turning it counter- clockwise and either push down or up on the lever. Pushing down on the lever will cause the balloon to rise. Pushing up on the lever will allow the balloon to be lowered. See insert A in Figure 11.

For circular positioning, swing the lever to the desired position. See insert B in Figure 11.

6.Before raising the mast, make sure the mast set screw (Figure 12) is securely tightened (use an 5mm-allen wrench to tighten). This will prevent the balloon/lamp assembly from falling off. In addition make sure the power cable from the generator is connected to the lamp power cable.

Figure 11. Positioning the Balloon

CAUTION - MAST PINCH POINT

When raising or lowering the mast, keep hands and fingers clear of the various mast sections, this will prevent hands and fingers from getting pinched.

7.Using the mechanical winch (Figure 13), raise the mast to the desired height. Turn winch handle clockwise to raise mast.

Figure 12. Mast Set Screw/Power Connections

Figure 13. MechanicalWinch Handle

GLOBUG LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #3 (03/22/06) — PAGE 25